• Anno
  • 1961 ?
  • Categoria
  • Radio (o sintonizzatore del dopoguerra WW2)
  • Radiomuseum.org ID
  • 119904

Clicca sulla miniatura dello schema per richiederlo come documento gratuito.

 Specifiche tecniche

  • Numero di tubi
  • 5
  • Numero di transistor
  • Principio generale
  • Supereterodina (in generale); ZF/IF 460/10700 kHz; Modello per l'esportazione
  • N. di circuiti accordati
  • 6 Circuiti Mod. Amp. (AM)     9 Circuiti Mod. Freq. (FM)
  • Gamme d'onda
  • Onde medie (OM), 2 gamme di onde corte (2 x OC) e MF (FM).
  • Tensioni di funzionamento
  • Alimentazione a corrente alternata (CA) / 110; 220 Volt
  • Altoparlante
  • 3 altoparlanti
  • Materiali
  • Mobile in legno
  • Radiomuseum.org
  • Modello: Gavotte 5353W - Telefunken Deutschland TFK,
  • Forma
  • Soprammobile con pulsantiera/tastiera.
  • Dimensioni (LxAxP)
  • 460 x 305 x 225 mm / 18.1 x 12 x 8.9 inch
  • Annotazioni
  • Telefunken Gavotte 5353W is an export model.
    See also the domestic models Gavotte 1153 and 1253.
    Coverage:
    FM 88-108 MHz,
    SW1 6.9-22 MHz,
    SW2 2.2-7 MHz,
    AM/MW 515-1620 kHz.
  • Autore
  • Modello inviato da Jozef Brughmans †. Utilizzare "Proponi modifica" per inviare ulteriori dati.

 Collezioni | Musei | Letteratura

Collezioni

Il modello Gavotte fa parte delle collezioni dei seguenti membri.

 Forum

Discussioni nel forum su questo modello: Telefunken: Gavotte 5353W

Argomenti: 1 | Articoli: 2

Hello All:

I could use some direction on troubleshooting this radio.  I have recapped it and replaced the selenium rectifiter.  The radio plays beautifully on FM and with an outside source through the phono input.  On AM, however, I have to turn the volume all the way up to barely hear the strongest AM stations.  The schematic only gives a few voltage specs which are all fine.  I've tried substituting tubes and have checked resistors but haven't found any issues.  I do have continuity from the antenna jacks to the AM switch, but f I touch the ferrite antenna there isn't any change in reception.  I've used a signal generator to generate a 460khz signal connected to an AM antenna to "broadcast" it and the radio picks up the tone.  On FM, the magic eye responds as expected.  On AM the magic eye stays open and doesn't move when tuning anywhere on the dial.  Poking around with a wooden stick hasn't uncovered any bad solder joints.

 

Any suggestions would be appreciated.

 

Thanks,

 

Mark

Allegati

Mark Pennington, 26.Feb.24

Weitere Posts (2) zu diesem Thema.