- Country
- Germany
- Manufacturer / Brand
- Nordmende, Norddeutsche Mende-Rundfunk GmbH (Sterling), Bremen-Hemelingen
- Year
- 1964 ?
- Category
- Broadcast Receiver - or past WW2 Tuner
- Radiomuseum.org ID
- 158266
- Number of Tubes
- 6
- Main principle
- Superheterodyne (common); Export model
- Wave bands
- Broadcast, 2 Short Wave plus FM or UHF.
- Power type and voltage
- Alternating Current supply (AC) / 110 Volt
- Loudspeaker
- 6 Loudspeakers
- Material
- Wooden case
- from Radiomuseum.org
- Model: Samba C - Nordmende, Norddeutsche Mende-
- Shape
- Console with any shape - in general
- Dimensions (WHD)
- 43 x 31 x 14 inch / 1092 x 787 x 356 mm
- Notes
- Nordmende Samba C is an export model.
This unit incorporates a DUAL 1007A changer. FM multiplex/stereo adapter can be retrofitted. FM coverage 88-108 MHz. 5-pin DIN female connector. 2 woofers, 2 mid range and 2 tweeters. There are also female connectors in back for extension speakers. Mono & Stereo sound from the LP changer and a tape deck, if connected with a 5 DIN plug.
- Net weight (2.2 lb = 1 kg)
- 50 kg / 110 lb 2.1 oz (110.132 lb)
- Author
- Model page created by Rolf Franke. See "Data change" for further contributors.
- Other Models
-
Here you find 1752 models, 1642 with images and 1270 with schematics for wireless sets etc. In French: TSF for Télégraphie sans fil.
All listed radios etc. from Nordmende, Norddeutsche Mende-Rundfunk GmbH (Sterling), Bremen-Hemelingen
Collections
The model Samba C is part of the collections of the following members.
Forum contributions about this model: Nordmende,: Samba C
Threads: 1 | Posts: 4
Looking for an expert opinion/advise.
Part of my collection of audio equipment is a 1964 NORDMENDE Samba C Stereo Console. Built-in is a DUAL 1007A changer with a CDS620 ceramic cartridge.
I don't operate the unit very often, but lately the output when playing LP's is very much reduced and rather flat (not so radio receiver operation).
The problem started slowly, cutting in and out of normal with some crackling, until the now present condition.
I suspected the ECC808 tube and replaced it, but it made no difference.
That leaves the cartridge, or perhaps one of the components on the circuit board.
Any suggestion, anyone?
Rolf Franke, 26.Mar.17