RF Signal Generator 088 three output binding posts

Philco, Philadelphia Stg. Batt. Co.; USA

  • Année
  • 1937 ?
  • Catégorie
  • Appareils de mesure et de dépannage (matériel de labo)
  • Radiomuseum.org ID
  • 249100

Cliquez sur la vignette du schéma pour le demander en tant que document gratuit.

 Spécifications techniques

  • No. de tubes
  • 1
  • Lampes / Tubes
  • 1C6
  • Gammes d'ondes
  • Bandes en notes
  • Tension / type courant
  • Piles sèches / 2 x 1.5 & 3 x 22.5 Volt
  • Haut-parleur
  • - - Pas de sortie basse fréquence
  • Matière
  • Boitier métallique
  • De Radiomuseum.org
  • Modèle: RF Signal Generator 088 [three output binding posts] - Philco, Philadelphia Stg. Batt
  • Forme
  • Modèle de table générique
  • Dimensions (LHP)
  • 255 x 170 x 155 mm / 10 x 6.7 x 6.1 inch
  • Remarques
  • This RF generator covers the range of 110 kHz to 20 MHz in five ranges.   This later version from 1937 has three output binding posts (high, medium, and ground) and includes the modulation on/off switch.

    The unit is powered by two 1.5 V "D" batteries and three 22.5 V batteries.

    There is also an early version from 1934/35 which has only two output binding posts (antenna and ground) and no modulation on/off switch.

  • Schémathèque (1)
  • - - Manufacturers Literature (Philco Radio Test Equipment Manual Dated 1948)
  • Auteur
  • Modèle crée par Torbjörn Hansson. Voir les propositions de modification pour les contributeurs supplémentaires.

 Collections | Musées | Littérature

Collections

Le modèle RF Signal Generator fait partie des collections des membres suivants.

 Forum