28X Ch= RC-1002
RCA (RCA Victor Co. Inc.); New York (NY)
- Country
- United States of America (USA)
- Manufacturer / Brand
- RCA (RCA Victor Co. Inc.); New York (NY)
- Year
- 1941/1942
- Category
- Broadcast Receiver - or past WW2 Tuner
- Radiomuseum.org ID
- 53337
-
- alternative name: RCA Manufacturing || Victor Talking Machine
Oliveira
Copy gen. von Bill Meacham Radio Attic
Scanned from the Radio Retailing July 1941.
Click on the schematic thumbnail to request the schematic as a free document.
- Number of Tubes
- 8
- Main principle
- Superhet with RF-stage; ZF/IF 455 kHz
- Wave bands
- Broadcast and Short Wave (SW).
- Power type and voltage
- AC/DC-set / 105-125 Volt
- Loudspeaker
- Permanent Magnet Dynamic (PDyn) Loudspeaker (moving coil) / Ø 9.25 inch = 23.5 cm
- Material
- Wooden case
- from Radiomuseum.org
- Model: 28X Ch= RC-1002 - RCA RCA Victor Co. Inc.; New
- Shape
- Tablemodel, with any shape - general.
- Dimensions (WHD)
- 15 x 10.7 x 9.5 inch / 381 x 272 x 241 mm
- Notes
- 2 built-in antennas.
- External source of data
- Ernst Erb
- Source of data
- Collector's Guide to Antique Radios (6th edition)
- Circuit diagram reference
- Rider's Perpetual, Volume 13 = 1942 and before
- Mentioned in
- Machine Age to Jet Age III
- Literature/Schematics (1)
- RCA Victor Instruments, Service Notes, 1941-1942.
- Literature/Schematics (2)
- Radio Retailing (Radio & Television R.) (July 1941. December 1941 page 34.)
- Other Models
-
Here you find 5137 models, 3241 with images and 4175 with schematics for wireless sets etc. In French: TSF for Télégraphie sans fil.
All listed radios etc. from RCA (RCA Victor Co. Inc.); New York (NY)
Forum contributions about this model: RCA RCA Victor Co.: 28X Ch= RC-1002
Threads: 1 | Posts: 1
Hi:
I've got an RCA 28X that I restored and it is working very well, but the coil/transformer that is mounted on the back panel is loose and dangling. It is designated as L2 and L23 on the schematic and it is wound on a 3900 ohm resistor. I believe I could make a replacement if I knew the inductance & turns ratio for the component. Any information would be appreciated.
Thanks- Tom
Thomas Ranz, 25.Jan.13