H-458T6 Ch=V-2229-2
Westinghouse El. & Mfg. Co. - see also Canadian W.
- País
- Estados Unidos
- Fabricante / Marca
- Westinghouse El. & Mfg. Co. - see also Canadian W.
- Año
- 1954 ?
- Categoría
- Radio - o Sintonizador pasado WW2
- Radiomuseum.org ID
- 81307
-
- alternative name: Westinghouse El. Int.
Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.
- Numero de valvulas
- 6
- Principio principal
- Superheterodino en general; ZF/IF 455 kHz; 2 Etapas de AF
- Número de circuitos sintonía
- 6 Circuíto(s) AM
- Gama de ondas
- OM (onda media) solamente
- Especialidades
- Tocadiscos-autom o no-no sabemos
- Tensión de funcionamiento
- Red: Corriente alterna (CA, Inglés = AC) / 117 Volt
- Altavoz
- Altavoz dinámico (de imán permanente)
- de Radiomuseum.org
- Modelo: H-458T6 Ch=V-2229-2 - Westinghouse El. & Mfg. Co. -
- Procedencia de los datos
- Beitman Radio Diagrams, Vol. 15, 1955
- Autor
- Modelo creado por Egon Penker. Ver en "Modificar Ficha" los participantes posteriores.
- Otros modelos
-
Donde encontrará 3153 modelos, 1750 con imágenes y 2669 con esquemas.
Ir al listado general de Westinghouse El. & Mfg. Co. - see also Canadian W.
Contribuciones en el Foro acerca de este modelo: Westinghouse El. &: H-458T6 Ch=V-2229-2
Hilos: 1 | Mensajes: 6
I recently restored this Westinghouse H-458T6. I was able to bring it up on my variac when I first put it on the bench. It played on AM and on the phono input with my phone. I then disassembled and found that the main can cap had been replaced at some point. I thought oh, maybe I will not need to replace that. But after checking found it to be bad. So I proceeded to replace it and all the paper/wax caps. Checked all the voltages and everything appears to be within tolerance. I restored the cabinet and fixed some problem areas in the speaker cone. Bench tested it with the phono input and it sounds pretty good!
So time to put it back together. Unfortunately when I hooked up the antenna, I noticed that the AM was still on when switched to phono input. Can anyone provide some suggestions for what might cause this? If this is normal, is there anything that can be done to eliminate it? I was considering adding a switch to the antenna, but I was hoping to get some advise from someone here before I make any modifications like that..
Thanks! James
James Holava, 22.Feb.23