dynaco: FM-3; Dynatuner
? dynaco: FM-3; Dynatuner
![Antonio Fabio Colorito](https://www.radiomuseum.org/image.cfm?image=p6224079.jpg&width=120&height=140)
Hello everyone .
I have a problem with one dynaco fm3 . The discriminator transformer is unalignable , I can't get less than -2,5v on eyelet 32 so the signal does not pass ( normally there should be at least -8v)
The rf board , the if board and the multiplex section are working fine , the only problem seems to be the discriminator transformer itself .
I also opened the transformer , refreshed the solder joints and tried to replace the pair of diodes inside the transformer and the 33pF capacitor but no success
Does anyone have any idea of what the problem should be and how to solve ?
Thank you , Antonio
To thank the Author because you find the post helpful or well done.
Please refine your question
Hi Antonio, do not quite understand the problem, the FM does not work, you hear little or distorted?
regards
To thank the Author because you find the post helpful or well done.
dynaco: FM-3; Dynatuner
![Antonio Fabio Colorito](https://www.radiomuseum.org/image.cfm?image=p6224079.jpg&width=120&height=140)
Thank you for your reply , the tuner is working but the sound is weak and distorted , as the discriminator is un-alignable
All the rest of the tuner is working fine , RF , IF ,stereo decoder and the audio output are working , all the voltages through the tuner are correct
Thank you very much , best regards
To thank the Author because you find the post helpful or well done.