ACEC stereo radio Type 5821
ACEC, Ateliers de Constructions Électriques de Charleroi; Charleroi
- Paese
- Belgio
- Produttore / Marca
- ACEC, Ateliers de Constructions Électriques de Charleroi; Charleroi
- Anno
- 1965
- Categoria
- Radio (o sintonizzatore del dopoguerra WW2)
- Radiomuseum.org ID
- 69092
Clicca sulla miniatura dello schema per richiederlo come documento gratuito.
- Numero di tubi
- 10
- Principio generale
- Supereterodina (in generale); ZF/IF 452 kHz; 3 Stadi BF
- N. di circuiti accordati
- 6 Circuiti Mod. Amp. (AM) 9 Circuiti Mod. Freq. (FM)
- Gamme d'onda
- Onde medie (OM), lunghe (OL), corte (OC) e MF (FM).
- Tensioni di funzionamento
- Alimentazione a corrente alternata (CA) / 110-245 Volt
- Altoparlante
- 2 altoparlanti / Ø 16 cm = 6.3 inch
- Potenza d'uscita
- 2 W (qualità ignota)
- Materiali
- Mobile in legno
- Radiomuseum.org
- Modello: ACEC stereo radio Type 5821 - ACEC, Ateliers de
- Forma
- Soprammobile con qualsiasi forma (non saputo).
- Dimensioni (LxAxP)
- 630 x 370 x 240 mm / 24.8 x 14.6 x 9.4 inch
- Annotazioni
- 2 x HP AD3700AM 800 Ohm. Fabricant: Atelier de Construction d'Electricité de Charleroi(ACEC).
- Peso netto
- 13.4 kg / 29 lb 8.2 oz (29.515 lb)
- Fonte esterna dei dati
- WDG
- Altri modelli
-
In questo link sono elencati 256 modelli, di cui 252 con immagini e 42 con schemi.
Elenco delle radio e altri apparecchi della ACEC, Ateliers de Constructions Électriques de Charleroi; Charleroi
Collezioni
Il modello ACEC stereo radio fa parte delle collezioni dei seguenti membri.
Discussioni nel forum su questo modello: ACEC, Ateliers de: ACEC stereo radio Type 5821
Argomenti: 1 | Articoli: 1
I found two probable lacks in the schematic available on the Radiomuseum site for the ACEC 5821
1/ On the first page, on the FM tuner, for the second triode, the oscillator,
the primary coil of the tuned coupling transformer fed by the anode through the 8.2pf needs to be grounded
at the other terminal
otherwise nothing is feeding the feed back circuit and there will be no oscillation, at least no tuned oscillation.
2/ On the second page, in the AGC loop, I think that the low pass filtering capacitor is missing.
The two grids, the one of the heptode ECH81 and the one of the pentode EF89 received the AGC without low pass (which is normally smoothing the gain command). This lack may also introduce a AC coupling beetween the two stages.
There may be some bad consequences.
So according with the 1.8Mohms, a capacitor of 47nF or 0.1uF should be connected to the ground.
This is a very common, very convenient and safe practice
What do you think?
Best regards
Yves
Yves Barbin, 11.Sep.18