Voice Of The Stars 356A

Altec Lansing Corp.; Oklahoma City (OK)

  • Année
  • 1960 ??
  • Catégorie
  • Amplificateur BF ou mélangeur BF
  • Radiomuseum.org ID
  • 297956

 Spécifications techniques

  • No. de tubes
  • 6
  • Principe général
  • Amplification audio
  • Tension / type courant
  • Alimentation Courant Alternatif (CA) / 117 Volt
  • Puissance de sortie
  • 18 W (sans distorsion)
  • Matière
  • Boitier métallique
  • De Radiomuseum.org
  • Modèle: Voice Of The Stars 356A - Altec Lansing Corp.; Oklahoma
  • Forme
  • Appareil d'étagère
  • Dimensions (LHP)
  • 14.25 x 5.25 x 9 inch / 362 x 133 x 229 mm
  • Remarques
  • Altec "VOICE OF THE STARS" amplifier-mixer, model 356A. No information found on year of introduction; all indications suggest 1960 +/- 2 years.  Uses push-pull EL84 amp stage, 12AU7 driver, and two 12AX7's as preamps.  Designed to use optional plug-in microphone matching transformers.  Uses Peerless transformers, a company that was acquired by Altec.  Well-made steel chassis.  Steel cabinet with textured green finish.  The following specifications are quoted from manufacturer's installation manual.

    Power output:  18W at less than 2% THD from 70-15,000 Hz.  (26W music power output per EIA standard RS 234)

    Frequency response:  20-20,000Hz +/-1dB on high level input

    Frequency response:  30-10,000Hz +/-1dB on low level input

    Load impedance:  8 ohms, 16 ohms, and 250 ohms on 70V line connector

    High level input:  1M impedance; 370mV for rated output; barrier screw terminals can be set for "line level" or "phono"

    Low level input:  3.3M impedance; 3mV for rated output; XLR connector (intended for microphone)

    Noise level:  71dB below full output (high level); 52dB below full output (low level)

     

  • Auteur
  • Modèle crée par Tim McVey. Voir les propositions de modification pour les contributeurs supplémentaires.

 Collections | Musées | Littérature

Collections

Le modèle Voice Of The Stars fait partie des collections des membres suivants.

 Forum