Hotpoint Band-Master H55ME
Australian General Electric (GE Company Australia Ltd., Associated, AGE, Bandmaster, Hotpoint), Sydney
- Pays
- Australie
- Fabricant / Marque
- Australian General Electric (GE Company Australia Ltd., Associated, AGE, Bandmaster, Hotpoint), Sydney
- Année
- 1947/1948
- Catégorie
- Radio - ou tuner d'après la guerre 1939-45
- Radiomuseum.org ID
- 309394
-
- alternative name: General Electric Company of Australia Ltd.
- No. de tubes
- 5
- Principe général
- Super hétérodyne (en général); FI/IF 455 kHz
- Gammes d'ondes
- PO uniquement
- Tension / type courant
- Alimentation Courant Alternatif (CA) / 200-260 Volt
- Haut-parleur
- HP dynamique à aimant permanent + bobine mobile / Ø 5 inch = 12.7 cm
- Matière
- Bakélite ou plastique de type inconnu
- De Radiomuseum.org
- Modèle: Hotpoint Band-Master H55ME - Australian General Electric GE
- Forme
- Modèle de table sans poussoirs, modèle cheminée
- Remarques
-
See also AWA Radiola 512-M.
- Prix de mise sur le marché
- 24.30 AUS £
- Littérature
- -- Original prospect or advert
- Schémathèque (1)
- Australian Official Radio Service Manual AORSM (Volume 6, 1948, Page 103 (for AWA 512-M).)
- Auteur
- Modèle crée par Martin Kent. Voir les propositions de modification pour les contributeurs supplémentaires.
- D'autres Modèles
-
Vous pourrez trouver sous ce lien 364 modèles d'appareils, 141 avec des images et 86 avec des schémas.
Tous les appareils de Australian General Electric (GE Company Australia Ltd., Associated, AGE, Bandmaster, Hotpoint), Sydney
Collections
Le modèle Hotpoint Band-Master fait partie des collections des membres suivants.
Contributions du forum pour ce modèle: Australian General: Hotpoint Band-Master H55ME
Discussions: 1 | Publications: 1
Hello. Just to let you know that the photos uploaded for this page are not for this model. The model shown is for a H55MEZ which is quite different from the H55ME. The dial mechanism and dial glass are different, and the valve line up is also different. I notice that the same photos have actually been uploaded to the correct model page.
Regards, Stuart
Stuart Irwin, 21.May.22