• Año
  • 1917 ??
  • Categoría
  • Módulo de radio de antes de 1926 (ni parte ni manipulador)
  • Radiomuseum.org ID
  • 334763

Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.

 Especificaciones técnicas

  • Principio principal
  • RF-Circuit or wave trap (separate, can also be an antenna with amp.)
  • Gama de ondas
  • OM (onda media) solamente
  • Tensión de funcionamiento
  • No necesita alimentación
  • Altavoz
  • - - No hay salida de sonido.
  • Material
  • Madera
  • de Radiomuseum.org
  • Modelo: Loose coupler - Bunnell & Co., J.H.; Kings
  • Forma
  • Formas varias descritas en notas aparte.
  • Ancho, altura, profundidad
  • 14 x 5 x 5.5 inch / 356 x 127 x 140 mm
  • Anotaciones
    1. This is an loose coupler manufactured by the well known J.H. Bunnell & Co. pre 1919. The tuner comes from the Harold Greenwood wireless radio collection. Its paper Greenwood tag is undamaged and affixed to the underside of the base.
    2. The crystal receiver that use this coupler (see schematic) tunes from 600 KHz to 1410 KHz with the indoor 10 ft. antenna and a ground connection. With the moving coil completely outside and higher impedance static coil (left side) and moving coil switch at 0 position (right) the receiver tunes at 600 KHz. When moving sliding coil inside, the tuned frequency increase without touching any switch or variable capacitor. The tuned frequency increase also when the switch of the static coil is moved toward right, decreasing his inductance.
    3. A vintage “de Forest Crosley” 2 tube amplifier (2 x 201A tubes) is used on the test bench, in addition to high impedance (2000 ohms) headphones, as seen in related photos. 
    4. Measurements with a Rohde & Schwarz SM300 signal generator with the corresponding adapter for the impedance of a long wire antenna, shows a sensibility of around – 35 dBm over the AM band, with a decent signal to noise ratio in the headphones when the “de Forest Crosley” 2 tube amplifier is used. 
  • Peso neto
  • 1.750 kg / 3 lb 13.7 oz (3.855 lb)
  • Autor
  • Modelo creado por Serioja Tatu. Ver en "Modificar Ficha" los participantes posteriores.

 Colecciones | Museos | Literatura

Colecciones

El modelo Loose coupler es parte de las colecciones de los siguientes miembros.

 Forum