Mini-lab 603B
BWD Electronics Pty Ltd.; Mulgrave, Victoria
- Land
- Australien
- Hersteller / Marke
- BWD Electronics Pty Ltd.; Mulgrave, Victoria
- Jahr
- 1977
- Kategorie
- Service- oder Labor-Ausrüstung
- Radiomuseum.org ID
- 314841
- Anzahl Transistoren
- Halbleiter vorhanden.
- Halbleiter
- Wellenbereiche
- Wellen in den Bemerkungen.
- Betriebsart / Volt
- Wechselstromspeisung / 95-135V/195-265 Volt
- Material
- Metallausführung
- von Radiomuseum.org
- Modell: Mini-lab 603B - BWD Electronics Pty Ltd.;
- Form
- Schweres Gerät für Militär oder Industrie (Boatanchor > 20 kg).
- Abmessungen (BHT)
- 420 x 260 x 200 mm / 16.5 x 10.2 x 7.9 inch
- Bemerkung
-
A most versatile instrument which combines a 0.001 Hz to 2MHz function generator with a 7W DC coupled power amplifier, an op-amp, sweep ramp generator and 3 DC power supplies. Inputs and outputs are quite independent or may be linked for a multitude of uses. The Function generator has variable ramp and pulse output, two levels of attenuation and may be swept over a 100: 1 range by its internal sweep ramp generator.
The Power amplifier which extends from DC to >80kHz also doubles as a 1 amp, bi-polar or voltage controlled power supply or as a fixed +5V 1 amp supply.FUNCTION GENERATOR
Range: 0.01 Hz to 1 M H z in 8 decade ranges. Plus, an additional 200kHz to 2MHz range. Uncalibrated range extends to 0.001 Hz.
Output: 0 - 10V P-P or 0 - 5V into 600Ω
0 - 1V P-P or 0 - 0.5V into 600Ω
Functions : Sine. square, triangle, ramp and pulse.
1: 1 to 50 : 1 ramp or pulse mark -space ratio TTL compatible output >3V into 2 TTL loads.
Output Offset : 0 to ±5V
Modulation : FM 1000 :1 DC coupled, with external signal.
AM 0 to 95% DC coupled, with external signal.
Sweep 100: 1 with internal sweep.
Sweep: Linear ramp variable >5s to approximately 50ms.
Sweeps over complete dial range down to any 10% portion of the range.POWER AMPLIF IER
Frequency Response: DC to 80kHz-3dB.
Output : 30V P-P current ± 1A P-P, constant current o/load, 7W into 15Ω
BI-POLAR POWER SUPPLY
Range: Continuously variable from -15V to +15V with 1A max. current at any voltage.
+5V POWER SUPPLY
Output : Fixed +5V Max current 1A.VOLTAGE/OPERATION A L AMPLIFIER
Frequency Response: DC to 80kHz
Gain: x 1 to x 100 continuously variable or may be switched with O/C feedback and isolated inputs: Input: 10kΩ each side or 0 .5MΩ isolated.
Slew Rate: 4V/us .DUAL POWER SUPPLY
Output: +1 to + 15V and -1 to- 15V about a common 0 line.
May be used as + and - rails to 15V or from ± 2 to ±30V as a single supply.
Current: 1A short circuit protected.
Line and load regulation: <1%HIGH VOLTAGE SUPPLY
Output: 0-200V, 30mA continuously variable
AC Output: 12.6V, 1A CT (6 .3-0-6.3) fused.
- Nettogewicht
- 10 kg / 22 lb 0.4 oz (22.026 lb)
- Literaturnachweis
- - - Manufacturers Literature (Test Instruments Short Form Catalogue No 7.)
- Autor
- Modellseite von Gary Cowans angelegt. Siehe bei "Änderungsvorschlag" für weitere Mitarbeit.
- Weitere Modelle
-
Hier finden Sie 24 Modelle, davon 17 mit Bildern und 6 mit Schaltbildern.
Alle gelisteten Radios usw. von BWD Electronics Pty Ltd.; Mulgrave, Victoria
Sammlungen
Das Modell Mini-lab befindet sich in den Sammlungen folgender Mitglieder.