Precision audio component / tuner amp DRA-400

Denon (Marke / brand)

Data
Forum
Pictures
Collections

  • Year
  • 1983
  • Category
  • Broadcast Receiver - or past WW2 Tuner
  • Radiomuseum.org ID
  • 150948

 Technical Specifications

  • Number of Transistors
  • Semiconductors present.
  • Semiconductors
  • Main principle
  • PLL, Phase-locked loop
  • Wave bands
  • Broadcast (BC) and FM or UHF.
  • Details
  • Hi-Fi equipment
  • Power type and voltage
  • Alternating Current supply (AC) / 120 or 200 or 220 or 240 Volt
  • Loudspeaker
  • - This model requires external speaker(s).
  • Power out
  • 80 W (100 W max.)
  • Material
  • Metal case
  • from Radiomuseum.org
  • Model: Precision audio component / tuner amp DRA-400 - Denon Marke / brand
  • Shape
  • Book-shelf unit.
  • Dimensions (WHD)
  • 434 x 112 x 408 mm / 17.1 x 4.4 x 16.1 inch
  • Notes

  • An AM/FM stereo hi-fi receiver with output power of 2 x 40 watts into 8 ohms or 2 x 50 watts RMS into 4 ohms. Inputs for Phono (selectable MM or MC) and Aux, input/output for 2 tapes. Connections for two pairs of loudspeakers and jack for headphones. Two AC outlets, 1 switched at 100 watts capacity, 1 un-switched at 250 watts capacity (not on European models). Tuning Down and Up, 5 AM/FM presets, Subsonic filter, Loudness and Mono/Stereo. Supplied with a clip-on AM loop antenna.

    Specification
    Power Amplifier Section
    Continuous Power Output:   40 W per channel minimum RMS,
                                                 both channels driven into 8 ohm from 20 Hz — 20 kHz
                                                 with no more than 0.02% total harmonic distortion
                                                (45 W per channel, 0.05% THD)
                                                 50 W per channel minimum RMS,
                                                 both channels driven into 4 ohm 1 kHz, THD 0.009%
    Total Harmonic Distortion:     0.02% (20 Hz to 20 kHz): rated power into 8 ohm
    Damping Factor:                   > 80 (at 1 kHz, 8 ohms)
    Power Bandwidth (IHF):         5 Hz - 40 kHz (THD 0.02% both ch. driven into 8 ohm)

    Pre-Amplifier Section
    Frequency Response:          ±0.5dB Phono RIAA Standard Curve (Recording Output)
                                                 ±0.5dB Tape, Aux  20 Hz — 20 kHz
    Input Sensitivity/ Impedance: PHONO MM 2.5 mV / 47 k ohm,
                                                  MC 0.25 mV / 100 ohm
                                                 TAPE, AUX 150 mV / >33 k ohm        
    Signal/Noise Ratio (IHF-A):   PHONO MM 80 dB
                                                 PHONO MC 62 dB
                                                 TAPE, AUX 95 dB

    Tuner
    FM Receiving Range:           87.9 - 107.9 MHz (USA and Canada),
                                                 87.5 - 108.0 MHz (Europe)
    AM Receiving Range:           530 - 1620 kHz (USA and Canada),
                                                 522 - 1611 kHz (Europe)

    Versions/Power Requirements
    Europe                   / 220V AC 50Hz
    UK                          / 240V AC 50Hz
    USA                       / 120V AC 60Hz
    Hong Kong            / 200V AC 50Hz

  • Net weight (2.2 lb = 1 kg)
  • 9 kg / 19 lb 13.2 oz (19.824 lb)
  • Source of data
  • -- Collector info (Sammler)
  • Mentioned in
  • -- Original prospect or advert (1983 Denon Product Catalogue)
  • Literature/Schematics (1)
  • - - Manufacturers Literature (Service Manual model DRA-400)
  • Author
  • Model page created by Franz Scharner. See "Data change" for further contributors.

 Collections | Museums | Literature

 Forum