- Produttore / Marca
- DuMont Labs, Allen B., Inc.
- Anno
- 1956
- Categoria
- Radio (o sintonizzatore del dopoguerra WW2)
- Radiomuseum.org ID
- 82578
-
- alternative name: Dumont Television & Radio
Clicca sulla miniatura dello schema per richiederlo come documento gratuito.
- Numero di tubi
- 5
- Principio generale
- Supereterodina (in generale); ZF/IF 455 kHz; 2 Stadi BF
- N. di circuiti accordati
- 6 Circuiti Mod. Amp. (AM)
- Gamme d'onda
- Solo onde medie (OM).
- Tensioni di funzionamento
- Alimentazione a corrente alternata (CA) / 110 - 120 Volt
- Altoparlante
- AP magnetodinamico (magnete permanente e bobina mobile) / Ø 4 inch = 10.2 cm
- Materiali
- Plastica (non bachelite o catalina)
- Radiomuseum.org
- Modello: 1120 - DuMont Labs, Allen B., Inc.
- Forma
- Soprammobile compatto/con bordi arrotondati/midget senza pulsantiera/tastiera.<= 35 cm (Sometimes with handle but for mains only).
- Annotazioni
- The Dumont Model 1120 is an AC Operated 5 Tube AM Receiver.
- Riferimenti schemi
- Beitman Radio Diagrams Vol. 17, 1957
- Letteratura / Schemi (1)
- Photofact Folder, Howard W. SAMS (Date 4-57, Set 354, Folder 4)
- Autore
- Modello inviato da Egon Penker. Utilizzare "Proponi modifica" per inviare ulteriori dati.
- Altri modelli
-
In questo link sono elencati 305 modelli, di cui 158 con immagini e 246 con schemi.
Elenco delle radio e altri apparecchi della DuMont Labs, Allen B., Inc.
Discussioni nel forum su questo modello: DuMont Labs, Allen B: 1120
Argomenti: 2 | Articoli: 6
I'm preparing to restore the circuit of a Dumont 1120. I noticed that the measured resistances for couplet were far off. The 470K resistor between pin 5 and pin7 measured 1.8M ohms. The other 470K resistor between pin 6 and pin 4 measured 5.5M ohms. And the 10Meg resistor between Pin 1 and Pin4 measured 16.5M ohms.
Is it common for these to fail? I just had to rebuild one on a Sylvania R518 couplet.
Schematic included by DR
Allegati
- Couplet (49 KB)
Jay Graven, 01.Oct.21
Restoring a Dumont 1120 clock radio. Unfortunately all four screw posts have broken away from the cabinet. I still have the broken posts attached to the screws. Anyone know a good way to reglue the broken posts back to the cabinet? Will JB Weld work??
Jay Graven, 27.Sep.21