Power Supply 1262-B
General Radio Company; Cambridge (MA)
- Produttore / Marca
- General Radio Company; Cambridge (MA)
- Anno
- 1968
- Categoria
- Strumento da laboratorio
- Radiomuseum.org ID
- 309399
-
- alternative name: GenRad
Clicca sulla miniatura dello schema per richiederlo come documento gratuito.
- Gamme d'onda
- - senza
- Tensioni di funzionamento
- Alimentazione a corrente alternata (CA) / 110;220 Volt
- Altoparlante
- - - Nessuna uscita audio.
- Materiali
- Mobile di metallo
- Radiomuseum.org
- Modello: Power Supply 1262-B - General Radio Company;
- Forma
- Diverse forme (descritte nelle note).
- Dimensioni (LxAxP)
- 175 x 85 x 130 mm / 6.9 x 3.3 x 5.1 inch
- Annotazioni
-
Bolts on to end of the Sound-Level Meter 1551C. Not intended to be added or removed in normal use as the cover has to be removed. The 110V / 220V selection is by internal soldered wires on the transformer. It provides three filament and one HT supply via a 6 pin Jones plug, so don't connect to mains while not bolted on as one pin has about 65V.
- Autore
- Modello inviato da Michael Watterson. Utilizzare "Proponi modifica" per inviare ulteriori dati.
- Altri modelli
-
In questo link sono elencati 238 modelli, di cui 212 con immagini e 128 con schemi.
Elenco delle radio e altri apparecchi della General Radio Company; Cambridge (MA)
Collezioni
Il modello Power Supply fa parte delle collezioni dei seguenti membri.
Discussioni nel forum su questo modello: General Radio: Power Supply 1262-B
Argomenti: 1 | Articoli: 2
Examination of the Sound Level meter 1551-C reveals it has two filament supplies, 20mA and 40mA using two pins on the Jones connector or the two D size 1.5V cells. All the batteries must be removed before installing the PSU as the connections are shared. The third filament supply on pins 5 and 6 isn't used. It's floating unlike the other two filament supplies.
Examination of the PCB reveals that the HT supply winding and the other two filament supplies share a common ground / 0V connection. Actually the two used supplies use a common full wave rectifier and centre tapped winding, with only the filtering and selenium shunt regulator diodes being separate.
Perhaps the PCB or entire unit was used for another product or earlier model.
Michael Watterson, 28.Mar.19