• País
• Estados Unidos

• Fabricante / Marca
• General Radio Company; Cambridge (MA)

• Año
• 1968

• Categoría
• Aparato de medida y servicio (Equipo de laboratorio).

• Radiomuseum.org ID
• 279903

• • alternative name: GenRad

Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.

• Numero de valvulas
• 6

• Válvulas
• CK512AX CK512AX CK512AX CK512AX CK6418 CK6418

• Numero de transistores
• 1

• Semiconductores
• 2N1372

• Principio principal
• Amplificador de Audio

• Gama de ondas
• - no hay

• Tensión de funcionamiento
• Pilas + jack (etc.) para alimentación externa. / D: 2 x 1.5 & 67.5 Volt

• Altavoz
• - Este modelo usa amplificador externo de B.F.

• Material
• Metálico

• de Radiomuseum.org
• Modelo: Sound-Level Meter 1551-C - General Radio Company;

• Forma
• Portátil > 20 cm (sin la necesidad de una red)

• Ancho, altura, profundidad
• 7.25 x 9.25 x 6.125 inch / 184 x 235 x 156 mm

• Anotaciones

• A Battery powered Sound-level meter that can be used as a calibrated audio amplifier.

  Sound-Level Range: From 24 to 150 dB (re 20 μN/m²).
  Frequency Characteristics: Four response characteristics, A, B, C, or 20 kHz, as selected by panel switch. The A-, B-, and C- weighting positions are in accordance with USA Standard S1.4, 1961 and IEC Publication 123, 1961. Frequency response for the 20-kHz position is flat from 20 Hz to 20 kHz, so that complete use can be made of very wide-band microphones such as the 1551-P1 Condenser Microphone Systems.

  Microphone: GR Type 1560-P5 (a piezo type). The 1551-P1 Condenser Microphone (an Electret with no internal FET buffer?) was an option, but a piezo type microphone was usually supplied.

  Sound·Level Indication: Sound level is indicated by the meter and attenuator readings. The clearly marked, meter covers a span of 16 dB with calibration from -6 to +10 dB.
  The attenuator is calibrated in 10-dB steps from 30 to 140 dB above 20 μN/m².

  There are 7 semiconductor diodes as well as the transistor:

  • 4 x 1N34A (D1 to D4)
  • 2 x 1N645 (D5, D6)
  • 1 x 1N967B (RX51), which is a Zener diode.

  The rear has soft mounts and the main amplifier PCB has also soft rubber anti-vibration mounts.

  Batteries

  The 1.5 V LT is 2 x D Cells powering separate filament circuits. The CK512AX are in series-pairs being 0.625V filaments.

  The HT pack was commonly used in 1950s small and Personal Sets, the Eveready / NCC 467 or any equivalent. The mains power supply unit 1262-C is an optional extra that is screwed on, the 120V / 240V switching is a soldered wire inside!

  Filament batteries (LT 2x D-cells) should last 6 to 7 days at 8 hours a day, or 30
  to 35 days at 2 hours a day. The 67.5V HT battery should last 12 to 14 days at
  8 hours a day, or 60 to 70 days at 2 hours a day.

  There is a long life button cell mounted inside the amplifier unit under the PCB. It's used to bias the input amplfier grid at -1.4V. The manual is confusing: undo the amplifier cover (two screws). Then unscrew the two pillars the screws used. The PCB can then swing down. Next pull off the spring clip. The cell simply unscrews as it has an integral bolt! Any Silver Oxide cell of a similar size will do once you've made a custom holder. Make sure -ve goes to clip and +ve to the wire leaving the amplifier case. Do not use Zinc Air as they self-discharge. An Alkaline Manganese will work, but not as good as the silver cell. A lithium cell is too high a voltage (3V).

  Output: 1.4 V (panel meter at full scale). The output can be used to drive analysers, recorders, oscilloscopes, and headphones. Harmonic distortion (panel meter at full scale) <1 %.

  Input Impedance: 25 M Ohms in parallel with 50 pF. The microphone uses a Cannon plug / Socket so an external signal (30 microvolts) can feed the amplifier or a different microphone.

  Army technical bulletin TB 9-4931-413-50 "Calibration procedure for Sound-level meter, General Radio, models 1551C, 1565A and 1565B"

• Peso neto
• 7.75 lb (7 lb 12 oz) / 3.519 kg

• Procedencia de los datos
• -- Original-techn. papers.

• Mencionado en
• -- Original-techn. papers.

• Autor
• Modelo creado por Gottfried Silberhorn. Ver en "Modificar Ficha" los participantes posteriores.

• Otros modelos

• Donde encontrará 241 modelos, 212 con imágenes y 131 con esquemas.
  Ir al listado general de General Radio Company; Cambridge (MA)