• Année
  • 1946/1947
  • Catégorie
  • Radio - ou tuner d'après la guerre 1939-45
  • Radiomuseum.org ID
  • 41883
    • Brand: Musaphonic

Cliquez sur la vignette du schéma pour le demander en tant que document gratuit.

 Spécifications techniques

  • No. de tubes
  • 6
  • Principe général
  • Super hétérodyne (en général); FI/IF 455 kHz; 2 Etage(s) BF
  • Circuits accordés
  • 6 Circuits MA (AM)
  • Gammes d'ondes
  • PO uniquement
  • Particularités
  • Tourne disque avec changeur
  • Tension / type courant
  • Alimentation Courant Alternatif (CA) / 105 - 125 Volt
  • Haut-parleur
  • HP dynamique à aimant permanent + bobine mobile / Ø 6.5 inch = 16.5 cm
  • Puissance de sortie
  • 3 W (qualité inconnue)
  • Matière
  • Boitier en bois
  • De Radiomuseum.org
  • Modèle: 304 - General Electric Co. GE;
  • Forme
  • Modèle de table boitier avec vouvercle
  • Dimensions (LHP)
  • 16 x 10.4375 x 15.625 inch / 406 x 265 x 397 mm
  • Remarques
  • Record Changer: GE P-1. Built-in Beam-a-scope antenna. Walnut cabinet.

  • Source extérieure
  • Ernst Erb
  • Source du schéma
  • Rider's Perpetual, Volume 18 = 1949 and before
  • Schémathèque (3)
  • General Electric Folder 1000M-PUB.NO. 175-59 for 1947.

 Collections | Musées | Littérature

Collections

Le modèle 304 fait partie des collections des membres suivants.

 Forum

Contributions du forum pour ce modèle: General Electric Co.: 304

Discussions: 1 | Publications: 4

I recently started a full restoration of this classic radio.  Before the restoration, the radio was working, but I never let it run very long for fear of damaging components before recapping.

I swapped out all the usual suspects, including the electrolytic caps.  There's only 1 cap that hasn't been replaced (C20) a 1000v, but I don't think that this is the problem. (Just a guess)

What happens is that the radio works great as it warms up. I receive a strong signal and can tune the radio, but after 10 seconds, the sound starts to weaken and quickly is gone.  

I'm just looking for some guidance on what to be looking for (i.e. a tube problem or a resistor problem).  Any help is appreciated!

thanks.

craig.

 

 

Craig Vodnik, 20.May.13

Weitere Posts (4) zu diesem Thema.