• Anno
  • 1958–1962
  • Categoria
  • Ricevitore amatoriale (può includere bande broadcast)
  • Radiomuseum.org ID
  • 79166

Clicca sulla miniatura dello schema per richiederlo come documento gratuito.

 Specifiche tecniche

  • Numero di tubi
  • 8
  • Principio generale
  • Supereterodina (in generale); ZF/IF 455 kHz
  • Gamme d'onda
  • Onde medie (OM) e più di 2 gamme di onde corte (> 2 x OC).
  • Tensioni di funzionamento
  • Alimentazione a corrente alternata (CA) / 105-125 Volt
  • Altoparlante
  • AP magnetodinamico (magnete permanente e bobina mobile) / Ø 5 inch = 12.7 cm
  • Potenza d'uscita
  • 1 W (qualità ignota)
  • Materiali
  • Mobile di metallo
  • Radiomuseum.org
  • Modello: S-107 - Hallicrafters, The; Chicago,
  • Forma
  • Soprammobile basso, con andamento orizzontale (grosse dimensioni).
  • Dimensioni (LxAxP)
  • 340 x 225 x 178 mm / 13.4 x 8.9 x 7 inch
  • Annotazioni
  • Coverage: 0.54-1.63, 2.5-6.3, 6.3-16, 14-31, 48-54.5MHz, the S-107 replaces the S-53A

    The original price of $60 is from the Radio by Hallicrafters book (1996, page 69).   This price most likely is a typo since it appears low for a model of this type.  The 1959 Sears ad lists this radio for $89.95 and that price appears to be more reasonable. 

  • Peso netto
  • 7.2 kg / 15 lb 13.7 oz (15.859 lb)
  • Prezzo nel primo anno
  • 60.00 $
  • Autore
  • Modello inviato da un iscritto da D. Utilizzare "Proponi modifica" per inviare ulteriori dati.

 Collezioni | Musei | Letteratura

Collezioni

Il modello fa parte delle collezioni dei seguenti membri.

 Forum

Discussioni nel forum su questo modello: Hallicrafters, The;: S-107

Argomenti: 2 | Articoli: 5

Our member Sinisa Trlin has the following problem:

Why is the Twin Diode 6AL5 filament heating reduced by a 6.8 ohm series resistor?
Specified for 6.3 V / 0.3 amp it is connected via said resistor to the common 6.3 V filament supply.

Such is found in many (all?) post-war models, e.g. S-40, S-53, S-76, 8R40, SX-90,
SX-130, etc.
Pre-war models S-19R and SX-24 are not equipped wich such a series resistor.

Even VTVMs are using the heater reduction.
Same is found for other Twin Diodes like 6H6 or EAA91.

What is the technical reason to reduce emission in such tubes?
To reduce the residual current at the characteristic bend?

Konrad Birkner † 12.08.2014, 17.Mar.13

Weitere Posts (3) zu diesem Thema.

Unser Mitglied Sinisa Trlin bat mich folgendes zu fragen:

Warum wird die 6AL5 absichtlich unterheizt?
Sie hat einen 6,8 Ohm Vorwiderstand, obwohl sie mit 6.3 V 0,3 A spezifiziert ist und die Heizspannung für das gesamte Gerät ebenfalls 6,3 V beträgt?

Das findet sich bei vielen (evtl.allen?) Nachkriegsmodellen, z.B. S-40, S-53, S-76, 8R40,
SX-90, SX-130 etc.
Die Vorkriegsmodelle S-19R und SX-24 verwenden keinen Vorwiderstand.

Auch bei Röhrenvoltmetern findet sich Unterheizung der Duodiode (z.B. auch 6H6 oder EAA91 u.a.).

Was ist der genaue Grund Signal-Messgleichrichterdioden zu unterheizen?
Anlaufstrom / Kennlinienknick?

 

Konrad Birkner † 12.08.2014, 17.Mar.13

Weitere Posts (2) zu diesem Thema.