Sky Traveler S-29
Hallicrafters, The; Chicago, IL and Arlington/Grand Prairie, TX
- Produttore / Marca
- Hallicrafters, The; Chicago, IL and Arlington/Grand Prairie, TX
- Anno
- 1940–1943
- Categoria
- Ricevitore amatoriale (può includere bande broadcast)
- Radiomuseum.org ID
- 18689
Clicca sulla miniatura dello schema per richiederlo come documento gratuito.
- Numero di tubi
- 9
- Principio generale
- Supereterodina con stadio RF; ZF/IF 455 kHz
- Gamme d'onda
- Gamme d'onda nelle note.
- Tensioni di funzionamento
- Rete / Batterie (ogni tipo) / 110; 6 & 90 Volt
- Altoparlante
- AP magnetodinamico (magnete permanente e bobina mobile)
- Materiali
- Mobile di metallo
- Radiomuseum.org
- Modello: Sky Traveler S-29 - Hallicrafters, The; Chicago,
- Forma
- Apparecchio portatile > 20 cm (senza la necessità di una rete)
- Dimensioni (LxAxP)
- 7 x 8.5 x 13.2 inch / 178 x 216 x 335 mm
- Annotazioni
- Coverage 0.54 - 30.5 MHz in four ranges, bandspread in 80/40/20/10m HAM bands; built in telescopic antenna. 10.000 built during WWII.
- Prezzo nel primo anno
- 60.00 $
- Fonte esterna dei dati
- E. Erb 3-907007-36-0
- Fonte dei dati
- Communications Receivers
- Riferimenti schemi
- Rider's Perpetual, Volume 12 = ca. 1941 and before
- Bibliografia
- ARRL Handbook 1942 Catalog Section
- Letteratura / Schemi (1)
- Radio Retailing (Radio & Television R.) (April 1941.)
Manual for the Hallicrafters S-29, made by Hallicrafters. | 1030 KB |
- Documenti su questo modello
- Altri modelli
-
In questo link sono elencati 926 modelli, di cui 476 con immagini e 526 con schemi.
Elenco delle radio e altri apparecchi della Hallicrafters, The; Chicago, IL and Arlington/Grand Prairie, TX
Collezioni
Il modello Sky Traveler fa parte delle collezioni dei seguenti membri.
Discussioni nel forum su questo modello: Hallicrafters, The;: Sky Traveler S-29
Argomenti: 1 | Articoli: 4
I have restored a Hallicrafters S-29, but sensitivity appears to be less than what I'd expect on the broadcast band. Making some signal generator measurments (on any band), it takes about 3000 microvolts at the antenna to ground terminal to get a reasonable signal level, and at 1000 microvolts, it is just "hearable". A signal into the 455kc chain gives a good output at about 100 - 300 microvolts.
I have aligned it per manual instructions (I believe), and the voltages at the filaments and plates of the 1T4 and 1R5 all seem within bounds.
I realize it would be good to know what to expect as a sensitivity for, say, the broadcast band of this radio. I have not been able to find this figure anywhere.
Can anyone help guide me?
Best Regards,
Frank Pascale
Long Island, New York
Frank Pascale, 04.Oct.12