2 Valve Short Wave Receiver

Marconi's Wireless Telegraph Co. Ltd.

  • Anno
  • 1923/1924 ?
  • Categoria
  • Ricevitore professionale (può includere bande amatoriali)
  • Radiomuseum.org ID
  • 344000

Clicca sulla miniatura dello schema per richiederlo come documento gratuito.

 Specifiche tecniche

  • Numero di tubi
  • 2
  • Valvole
  • Principio generale
  • A reazione (con rigenerazione); 1 Stadi BF
  • Gamme d'onda
  • Onde corte (solamente OC)
  • Tensioni di funzionamento
  • Batterie a secco / 6;80;120 Volt
  • Altoparlante
  • - solo per cuffie o auricolari
  • Materiali
  • Mobile di metallo
  • Radiomuseum.org
  • Modello: 2 Valve Short Wave Receiver - Marconi's Wireless Telegraph
  • Forma
  • Soprammobile a cassapanca o cassetta, solitamente con coperchio (NON a leggio)
  • Dimensioni (LxAxP)
  • 430 x 255 x 210 mm / 16.9 x 10 x 8.3 inch
  • Annotazioni
  • This receiver matches the picture on page 56 of the January 13th, 1926 issue of "Wireless World". The picture heading states 'Short-wave receiver of the type used by Senatore Marconi in the short-wave experiments with the Poldhu station. Interchangeable coils produce a tuning range of 15 to 100 metres'.

    The "Marconi Review" No. 2 of November 1928 also refers to this receiver in the article: "A Chapter In The History Of The Marconi Beam II". Page 1 describes this receiver as follows: 'There were two receivers, designed by Mr. Mathieu, in use on the "Elettra." The first of these, a copper-screened two-valve instrument, having a waverange of 40 to 100 metres, was used for signal intensity tests, and employed, as shown in the circuit diagram, Fig. 5, an aperiodic aerial, a detector valve with reaction, a tuned grid circuit with vernier condenser, a low pass filter to isolate the telephone circuit from reaction effects, a low-frequency transformer and an audibility test circuit to which the telephone was connected. The test circuit consisted of an artificial line graduated in standard miles and providing a range of adjustment equivalent to 0 to 100 T.U.'

    Based on the picture, description and schematic, this may be the actual receiver used by Marconi during the short-wave tests conducted aboard his yacht, "Elettra". The serial number "1" stamped into the case also suggests that this was the initial prototype.

  • Peso netto
  • 16.4 lb (16 lb 6.4 oz) / 7.446 kg
  • Letteratura / Schemi (1)
  • - - Manufacturers Literature (The Marconi Review, No. 2, November 1928, page 1)
  • Autore
  • Modello inviato da Gary Berg. Utilizzare "Proponi modifica" per inviare ulteriori dati.

 Collezioni | Musei | Letteratura

Collezioni

Il modello 2 Valve Short Wave Receiver fa parte delle collezioni dei seguenti membri.

 Forum