Reception Set R209/2/B
MILITARY U.K. (different makers for same model)
- País
- Gran Bretaña (GB)
- Fabricante / Marca
- MILITARY U.K. (different makers for same model)
- Año
- 1956 ?
- Categoría
- Receptor militar
- Radiomuseum.org ID
- 176755
Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.
- Numero de valvulas
- 10
- Válvulas
- CV131 or EF92 CV782 or 1R5 CV284 or 75B1 CV785 or 1T4 CV785 CV785 CV785 CV784 or 1S5 CV785 CV784 CV784
- Principio principal
- Superheterodino con paso previo de RF; ZF/IF 460 kHz; 1 Etapas de AF
- Número de circuitos sintonía
- 7 Circuíto(s) AM
- Gama de ondas
- OM y más de dos OC
- Tensión de funcionamiento
- Red / Acumuladores (posiblemente también baterias) / 12; 24; 115; 220 Volt
- Altavoz
- Altavoz dinámico (de imán permanente) / Ø 8 cm = 3.1 inch
- Potencia de salida
- 0.05 W (unknown quality)
- Material
- Metálico
- de Radiomuseum.org
- Modelo: Reception Set R209/2/B - MILITARY U.K. different makers
- Forma
- Boatanchor (militar, profesional >20 kg).
- Ancho, altura, profundidad
- 310 x 215 x 230 mm / 12.2 x 8.5 x 9.1 inch
- Anotaciones
- The R209/2/B reception set is a later variant of the R209 MK II general-purpose receiver. The construction is very solid and waterproof.
Antenna connections for wire/rod and for dipole ca. 80 ohms, with antenna-trimmer.
Frequency range in 4 bands 1,0-2,3 MHz, 2,3-5,6 MHz, 5,5-12,5 MHz, 12,0-20,0 MHz. Sigal modes AM/CW/FM. The BFO is variable to tune an audio-peak at ca. 950 Hz.
The FM-mode is present because of the existing circuitry, but it is rather useless. V8, CV784 acts in FM-mode as IF-limiter and the diode section is the discriminator. The audio stage is push-pull, with a 10 ohm speaker and a socket for two extra 150 ohm headphones.
The set lacks the IF-signal-out connector, at it's place, the on/off switch is located now.
It has a new PSU, 12 volts or 24 volts battery supply, as well as mains-supply 110 and 220 volts. The mains transformer also enables 230 volts. For mains supply a second connecting-cable is supplied. The voltage selector is found left at the top, besides the now locked fuseholder.
A spare box with different fuses and a spare desiccator is supplied.
Valves are specified after their schematic-numbering.
- Peso neto
- 10.9 kg / 24 lb 0.1 oz (24.009 lb)
- Procedencia de los datos
- - - Data from my own collection
- Mencionado en
- Wireless for the Warrior; L.Meulstee (Vol. 3)
- Documentación / Esquemas (1)
- equipment manual Mullard London, 1956
- Autor
- Modelo creado por Jan Terranea. Ver en "Modificar Ficha" los participantes posteriores.
- Otros modelos
-
Donde encontrará 152 modelos, 120 con imágenes y 48 con esquemas.
Ir al listado general de MILITARY U.K. (different makers for same model)
Colecciones
El modelo Reception Set es parte de las colecciones de los siguientes miembros.