Oscilloscope - Test Set TS-182/UP
MILITARY U.S. (different makers for same model)
- Pays
- Etats-Unis
- Fabricant / Marque
- MILITARY U.S. (different makers for same model)
- Année
- 1945
- Catégorie
- Appareils de mesure et de dépannage (matériel de labo)
- Radiomuseum.org ID
- 206075
Cliquez sur la vignette du schéma pour le demander en tant que document gratuit.
- No. de tubes
- 11
- Gammes d'ondes
- Bandes en notes
- Tension / type courant
- Alimentation Courant Alternatif (CA) / 115 Volt
- Haut-parleur
- - - Pas de sortie basse fréquence
- Matière
- Boitier métallique
- De Radiomuseum.org
- Modèle: Oscilloscope - Test Set TS-182/UP - MILITARY U.S. different makers
- Forme
- Gros appareil industriel ou militaire (> 20 kg)
- Remarques
- This equipment operates from a 115 volt 50 - 120 Hz mains supply and is primarily intended for checking the sensitivity of receivers and the power output of transmitters intended to receive and transmit pulse-modulated signals. The equipment operates over a frequency range of 150 to 240 MHz and may be used, in addition, to roughly check the frequency of operation of receiving equipment operating within this range. The unit is further suitable for displaying with good fidelity the actual pulse shape of short r-f pulses (from 2 to 200 microseconds long) on the built-in cathode ray oscilloscope and can, therefore, also serve as a means for comparing the length of r-f pulses. The unit is capable of making the following measurements: (1) Receiver sensitivity, (2) R-F pulse power up to 3000 peak watts, (3) Transponder Sensitivity and Power Output, (4) R-F pulse shapes and durations, (5) Video pulse shapes and durations. This unit is suited for supplying pulse-modulated r-f voltages of a known magnitude to any receiver intended to receive pulse-modulated signals, capable of operating within the frequency band of 150 to 240 MHz and having an input impedance of approximately 50 ohms. In addition, the receiver under test must be capable of delivering a video output signal of at least one volt peak before any limiting begins. Demonstrating the simplicity of design also present in the TS-148 test set, this TS-182 unit has sophisticated circuits (for its day: 1945) with a minimum of component count. For instance, a "delay one-kick multivibrator" is incorporated to delay the r-f pulse generated by the r-f oscillator by about 20 microseconds following the beginning of the oscilloscope sweep, so that any indication appearing on the oscilloscope of this equipment will likewise appear a short distance from the left of the sweep where it can be more readily observed. The attached schematic further demonstrates this spartan, yet highly functional design. Using a tube count of only eleven devices, the TS-182 test set includes an oscillator for generating the signals then measured after return from the device under test to both a meter and oscilloscope data display combination.
- Poids net
- 49 lb (49 lb 0 oz) / 22.246 kg
- Schémathèque (3)
- -- Schematic
- Auteur
- Modèle crée par Hank Kaczmarski. Voir les propositions de modification pour les contributeurs supplémentaires.
- D'autres Modèles
-
Vous pourrez trouver sous ce lien 398 modèles d'appareils, 350 avec des images et 210 avec des schémas.
Tous les appareils de MILITARY U.S. (different makers for same model)
Collections
Le modèle Oscilloscope - Test Set fait partie des collections des membres suivants.