Stereo Amplifier 7W

Mullard Wireless, London (see also Mullard Radio Valve)

Dati
Forum
Immagini
Collezioni

  • Anno
  • 1958
  • Categoria
  • Amplificatore audio o mixer audio
  • Radiomuseum.org ID
  • 283539

Clicca sulla miniatura dello schema per richiederlo come documento gratuito.

 Specifiche tecniche

  • Numero di tubi
  • 6
  • Principio generale
  • Amplificatore audio
  • Gamme d'onda
  • - senza
  • Tensioni di funzionamento
  • Alimentazione a corrente alternata (CA) / 200-250 Volt
  • Altoparlante
  • - Questo apparecchio richiede altoparlante/i esterno/i.
  • Potenza d'uscita
  • 14 W (indistorta)
  • Materiali
  • Mobile di metallo, valvole visibili
  • Radiomuseum.org
  • Modello: Stereo Amplifier 7W - Mullard Wireless, London see
  • Forma
  • Chassis o in scatola da montaggio
  • Annotazioni

  • The circuit diagram drawn in Fig. 1 is for a high-quality, dual-channel amplifier designed principally for stereophonic reproduction but also providing facilities for monaural applications. Only one channel of the amplifier is drawn. The circuitry appearing between the dotted lines is for the left-hand channel: it should be duplicated for the right-hand channel. The circuitry drawn outside the dotted lines (the power supply, for example) is common to both channels.

    The total complement of valves used in the amplifier consists of one double triode, type ECC83, four triode pentodes, type ECL82, and one full-wave rectifier, type EZ81. The double triode is shared between the two channels, one section of the valve being used in each channel for voltage amplification. Two of the ECL82 are used in each channel. The triode sections of these valves form a phase-splitting stage and the pentode sections are arranged as a push-pull output stage with distributed loading. The EZ81 forms a conventional power supply with resistance-capacitance smoothing, providing the h.t. for both channels.

    The rated output-power reserve of each channel is 7W, at which level the total harmonic distortion is always better than 1.0 %. The low level of distortion is achieved by using 21dB of negative feedback, the feedback voltage being taken from the secondary winding of the output transformer in each channel to the cathode circuit of the corresponding input stage. The sensitivity of the circuit, even with this high value of feedback, is 120mV, which is ample for use with existing stereophonic crystal pick-up heads.

  • Bibliografia
  • - - Manufacturers Literature
  • Autore
  • Modello inviato da Gary Cowans. Utilizzare "Proponi modifica" per inviare ulteriori dati.

 Collezioni | Musei | Letteratura

 Forum