Globetraveler III (3) Ch= 9.101E

Nordmende, Norddeutsche Mende-Rundfunk GmbH (Sterling), Bremen-Hemelingen

Données
Forum
Images
Collections

  • Année
  • 1970 ?
  • Catégorie
  • Radio - ou tuner d'après la guerre 1939-45
  • Radiomuseum.org ID
  • 137911

 Spécifications techniques

  • No. de transistors
  • Semi-conducteurs présents
  • Semi-conducteurs
  • Principe général
  • Super hétérodyne (en général)
  • Gammes d'ondes
  • Bandes en notes
  • Tension / type courant
  • Secteur et Piles (tous types). / 110; ? Volt
  • Haut-parleur
  • HP dynamique à aimant permanent + bobine mobile
  • Matière
  • Cuir / canvas / plastique mais autre matériel en dessous!
  • De Radiomuseum.org
  • Modèle: Globetraveler III Ch= 9.101E - Nordmende, Norddeutsche Mende-
  • Forme
  • Portative > 20 cm (sans nécessité secteur)
  • Dimensions (LHP)
  • 310 x 210 x 105 mm / 12.2 x 8.3 x 4.1 inch
  • Remarques

  • Nordmende Globetraveler III (3);
    Coverage:
    AM-MW/LW & FM,
    SW-MB: 1.5 - 3.5 MHz,
    SW turret tuner coverage:
    80 meters 3.65 - 3.85 MHz,
    61 meters 4.6 - 4.85 MHz,
    59 meters 4.85 - 5.1 MHz,
    49 meters 5.95 - 6.25 MHz,
    41 meters 7.0 - 7.5 MHz,
    31 meters 9.4 - 9.85 MHz,
    25 meters 11.5 - 12.1 MHz,
    20 meters 13.9 - 14.5 MHz,
    19 meters 14.5 - 15.6 MHz,
    16 meters 17.4 - 18.3 MHz,
    13 meters 21.1 - 22.0 MHz,
    AFC, telescopic antenna, bass and treble controls, tuning meter and bandwidth selectivity, DIN AF terminals & DIN ext. antenna in.

  • Source
  • -- Collector info (Sammler)
  • Auteur
  • Modèle crée par d'un membre de A. Voir les propositions de modification pour les contributeurs supplémentaires.

 Collections | Musées | Littérature

Collections

Le modèle Globetraveler III (3) fait partie des collections des membres suivants.

 Forum

Contributions du forum pour ce modèle: Nordmende,: Globetraveler III Ch= 9.101E

Discussions: 2 | Publications: 6

Hello:

My Globetraveler III (TN6000 Series) radio has a capacitor between the whip antenna and the radio circuit board. It has broken in half.

According to the Nordemende schematic diagram, it is a 4700pf capacitor and is not polarized. I suspect it might be needed for static electricity supression purposes, but I do not know for sure. I think it is a ceramic capacitor. There is a wire coming out of each end and it looks a lot like a small resistor.

Question: Will any non-polarized capacitor of the proper specifications be acceptable? Do I need to be concerned whether it is rated at (for example) 200 volts or 2000 volts? Do I need to be concerned about the capacitor material?

Any guidance will be greatly appreciated.

Thank you,

Michael Witas

Milwaukee, Wisconsin USA

 

 

 

Pièces jointes

Michael Witas, 27.Aug.12

Weitere Posts (3) zu diesem Thema.

Hello:

I need to replace a burned out dial light bulb in my Nordmende Globetraveler III. Can anyone help identify the correct bulb to use?

The main dial iight is a BA7S. But the dial light for the rotating shortwave dial is a very small wedge type bulb with no metal base. I cannot read the writing on it other than it is an Osram brand bulb.

The radio operates on 7.5 volts and the BA7S for the main dial light is a 7 volt bulb. So, I assume the wedge base bulb for the shortwave tuner is rated at 7 volts also.

Note: The Globetraveler II uses two BA7S bulbs. But for the slightly newer Globetraveler III, the shortwave tuner uses the wedge type bulb described above. I know this because I own both radio models and have taken them both apart. I am mentioning this only to provide additional clarification.

Any information regarding the bulb number used would be greatly appreciated.

Mike Witas

 

Michael Witas, 24.Jun.12

Weitere Posts (3) zu diesem Thema.