- Pays
- Etats-Unis
- Fabricant / Marque
- Philco, Philadelphia Stg. Batt. Co.; USA
- Année
- 1941/1942
- Catégorie
- Radio - ou tuner d'après la guerre 1939-45
- Radiomuseum.org ID
- 50815
Cliquez sur la vignette du schéma pour le demander en tant que document gratuit.
- No. de tubes
- 8
- Principe général
- Super hétérodyne (en général); FI/IF 455 kHz
- Gammes d'ondes
- PO et 2 x OC
- Tension / type courant
- Alimentation Courant Alternatif (CA) / 115 Volt
- Haut-parleur
- HP dynamique à électro-aimant (électrodynamique) / Ø 12 inch = 30.5 cm
- Puissance de sortie
- 9.8 W (qualité inconnue)
- Matière
- Boitier en bois
- De Radiomuseum.org
- Modèle: 42-380X - Philco, Philadelphia Stg. Batt
- Forme
- Console avec des boutons-poussoirs
- Dimensions (LHP)
- 28.6 x 39.5 x 13 inch / 726 x 1003 x 330 mm
- Source extérieure
- Ernst Erb
- Source du schéma
- Rider's Perpetual, Volume 14 = 1944 = before 1943
- Littérature
- A Flick of the Switch 1930-1950
- Schémathèque (1)
- Philco Radio 1928-1942 (Philco 1942 RMS Year Book)
- Schémathèque (2)
- Pre-War Consoles
- Schémathèque (3)
- Radio Retailing (Radio & Television R.) (January 1942.)
- D'autres Modèles
-
Vous pourrez trouver sous ce lien 4007 modèles d'appareils, 2207 avec des images et 3656 avec des schémas.
Tous les appareils de Philco, Philadelphia Stg. Batt. Co.; USA
Collections
Le modèle 42-380X fait partie des collections des membres suivants.
Contributions du forum pour ce modèle: Philco, Philadelphia: 42-380X
Discussions: 1 | Publications: 1
I bought a Philco 42-380X at a flea market. BC band worked fine, SW bands did not function at all. After exhaustive tube and component testing, I found a factory installed jumper wire on the complex bandswitch which shorted out the oscillator on the SW bands. After removal of this wire, the SW bands worked perfectly. I later found out this radio was produced shortly after the Dec 7, 1941 attack at Pearl Harbor and the federal government required all receivers capable of receiving SW to be disabled to prevent spies in the country from receiving information. Spotting this wire was difficult, as it was exactly the same wire type and coloring as all the other wires on the bandswitch, and all the solder joints were original. I had to trace each wire.
Charles Weigel, 02.Jun.22