- País
- Gran Bretaña (GB)
- Fabricante / Marca
- Philips Electrical, Lamps, Industrial - Miniwatt; London
- Año
- 1957 ?
- Categoría
- Radio - o Sintonizador pasado WW2
- Radiomuseum.org ID
- 146773
Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.
- Numero de valvulas
- 5
- Principio principal
- Superheterodino en general; ZF/IF 470 kHz; 2 Etapas de AF
- Número de circuitos sintonía
- 6 Circuíto(s) AM
- Gama de ondas
- OM y OL
- Tensión de funcionamiento
- Red: Aparato AC/DC. / 200-250 Volt
- Altavoz
- Altavoz dinámico (de imán permanente)
- Material
- Inyectado (se desconoce si bakelita o plástico).
- de Radiomuseum.org
- Modelo: 161U - Philips Electrical, Lamps,
- Forma
- Sobremesa de cualquier forma, detalles no conocidos.
- Ancho, altura, profundidad
- 12 x 8.5 x 6.75 inch / 305 x 216 x 171 mm
- Procedencia de los datos
- -- Schematic
- Referencia esquema
- Radio and TV Servicing books (R&TVS) book
- Autor
- Modelo creado por Keith Staines. Ver en "Modificar Ficha" los participantes posteriores.
- Otros modelos
-
Donde encontrará 427 modelos, 304 con imágenes y 286 con esquemas.
Ir al listado general de Philips Electrical, Lamps, Industrial - Miniwatt; London
Contribuciones en el Foro acerca de este modelo: Philips Electrical,: 161U
Hilos: 1 | Mensajes: 10
Gentlemen,
With specific reference to the excellemt 2006 forum posts about the items above. . . . .
I have recently acquired the Philips GB Service manual for the radio in question; and would like comments to clarify which specific part would be the replacement for items R5 and R19 in the power supply of the receiver.
The tube lineup consists of the 100mA series tubes.
However, the parts list only shows the following numbers 49.379.62 for "resistor" R5 and 49.379.67 for "resistor" part R19 - and they are identified as "Varite".
There are no values provided for the resistance or wattage or tolerances - would it be permissible to use the BRIMISTOR data to presume the appropriate replacement as equivalent to the CZ3?
Respectfully,
Robert
NOTE: I ask this question based upon substitution of the C1 regulator in my early Philips AL161 AC/DC receiver from Argentina
Robert Sarbell † 22.3.22, 13.Jan.10