- Pays
- Royaume Uni
- Fabricant / Marque
- Philips Electrical, Lamps, Industrial - Miniwatt; London
- Année
- 1957 ?
- Catégorie
- Radio - ou tuner d'après la guerre 1939-45
- Radiomuseum.org ID
- 146773
Cliquez sur la vignette du schéma pour le demander en tant que document gratuit.
- No. de tubes
- 5
- Principe général
- Super hétérodyne (en général); FI/IF 470 kHz; 2 Etage(s) BF
- Circuits accordés
- 6 Circuits MA (AM)
- Gammes d'ondes
- PO et GO
- Tension / type courant
- Appareil tous courants (CA / CC) / 200-250 Volt
- Haut-parleur
- HP dynamique à aimant permanent + bobine mobile
- Matière
- Bakélite ou plastique de type inconnu
- De Radiomuseum.org
- Modèle: 161U - Philips Electrical, Lamps,
- Forme
- Modèle de table générique
- Dimensions (LHP)
- 12 x 8.5 x 6.75 inch / 305 x 216 x 171 mm
- Source
- -- Schematic
- Source du schéma
- Radio and TV Servicing books (R&TVS) book
- Auteur
- Modèle crée par Keith Staines. Voir les propositions de modification pour les contributeurs supplémentaires.
- D'autres Modèles
-
Vous pourrez trouver sous ce lien 427 modèles d'appareils, 304 avec des images et 286 avec des schémas.
Tous les appareils de Philips Electrical, Lamps, Industrial - Miniwatt; London
Contributions du forum pour ce modèle: Philips Electrical,: 161U
Discussions: 1 | Publications: 10
Gentlemen,
With specific reference to the excellemt 2006 forum posts about the items above. . . . .
I have recently acquired the Philips GB Service manual for the radio in question; and would like comments to clarify which specific part would be the replacement for items R5 and R19 in the power supply of the receiver.
The tube lineup consists of the 100mA series tubes.
However, the parts list only shows the following numbers 49.379.62 for "resistor" R5 and 49.379.67 for "resistor" part R19 - and they are identified as "Varite".
There are no values provided for the resistance or wattage or tolerances - would it be permissible to use the BRIMISTOR data to presume the appropriate replacement as equivalent to the CZ3?
Respectfully,
Robert
NOTE: I ask this question based upon substitution of the C1 regulator in my early Philips AL161 AC/DC receiver from Argentina
Robert Sarbell † 22.3.22, 13.Jan.10