- Pays
- Pays-Bas
- Fabricant / Marque
- Philips; Eindhoven (tubes international!); Miniwatt
- Année
- 1958–1961
- Catégorie
- Enrégistreur et/ou reproducteur son/video
- Radiomuseum.org ID
- 161110
- Gammes d'ondes
- - sans
- Particularités
- Tourne disque sans changeur
- Tension / type courant
- Alimentation Courant Alternatif (CA) / 110; 127; 220 Volt
- Haut-parleur
- - Pour casque ou amplificateur BF
- Matière
- Bakélite ou plastique de type inconnu
- De Radiomuseum.org
- Modèle: AG2210/95 - Philips; Eindhoven tubes
- Forme
- Modèle de table générique
- Dimensions (LHP)
- 345 x 130 x 255 mm / 13.6 x 5.1 x 10 inch
- Remarques
- 4 speed record player. Automatic switch-off based on arm travel per revolution. Speed regulation with magnetic brake on motor spindle.
Intermediate wheel retracted on switch-off.
Arm lift with separate lever. Needle pressure can be set with dial on the arm hinge.
Black part of housing is Bakelite, top cover is grey and made of modern plastics (moulded)
- Prix de mise sur le marché
- 135.00 CHF
- Source
- -- Original prospect or advert
- Auteur
- Modèle crée par Wouter Nieuwlaat † 27.5.18. Voir les propositions de modification pour les contributeurs supplémentaires.
- D'autres Modèles
-
Vous pourrez trouver sous ce lien 5250 modèles d'appareils, 4394 avec des images et 3450 avec des schémas.
Tous les appareils de Philips; Eindhoven (tubes international!); Miniwatt
Collections
Le modèle fait partie des collections des membres suivants.
Contributions du forum pour ce modèle: Philips; Eindhoven: AG2210/95
Discussions: 1 | Publications: 1
When I acquired this record player, it would jump out of the groove when reaching the end of the record.
It turned out this was caused by the automatic switch-off function. The lever comes in very early, but is pushed back as long as the needle travels only a small way per revolution (still in the normal playing track). This lever was stuck, and it made the needle skip grooves ones it started touching.
To dismantle the mechanism you have to lift the rubber cover, and find a small hole in the turntable.
turn the table so that the hole is closest to the Philips brand name. Press with a medium/long screwdriver that is put straight down into the hole, and lift the turntable at the same time
Now you can access the intermediate wheel and motor spindle.
To remove the mechanism from the bottom half of the housing, you need to unscrew the sprung feet. There is no mounting screw in the middle, just grab the entire foot and turn anticlockwise!
Wouter Nieuwlaat † 27.5.18, 15.Sep.09