• País
• Japon

• Fabricante / Marca
• Pioneer Corporation; Tokyo

• Año
• 1977/1978

• Categoría
• Amplificador de audio o mezclador

• Radiomuseum.org ID
• 189631

Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.

• Numero de transistores
• 25

• Semiconductores

• Principio principal
• Amplificador de Audio

• Gama de ondas
• - no hay

• Especialidades
• Hi-Fi equipment

• Tensión de funcionamiento
• Red: Corriente alterna (CA, Inglés = AC) / 110; 120; 220; 240 Volt

• Altavoz
• - Este modelo usa altavoz exterior (1 o más).

• Potencia de salida
• 60 W (undistorted)

• Material
• Metálico

• de Radiomuseum.org
• Modelo: Stereo Amplifier SA-6500 II - Pioneer Corporation; Tokyo

• Forma
• Unidad para estanteria.

• Ancho, altura, profundidad
• 15 x 5.5 x 12.125 inch / 381 x 140 x 308 mm

• Anotaciones

• A hi-fi stereo integrated amplifier housed in a metal case (optional wooden case) with continuous power output of  2 x 30 Watts RMS into 8 ohms or 4 ohms, with no more than 0.1% THD.  Direct Coupled OCL, phono input uses TA7136P1 low noise preamplifier IC (one per channel). With rotary controls for Volume, Balance, Bass and Treble, rotary switch for Function (Phono, Tuner, Aux) and Speakers (Off, A, B, A+B), switches for Power, Tone bypass, Loudness, Tape Monitor 1 and 2 and a jack for Headphones. On the rear panel, RCA phono sockets for input Phono, Tuner, Aux, for input/output Tape1 and Tape2, on the HG and S versions a DIN socket for Tape2 Rec/Play, terminals for two pairs of loudspeakers (A, B) and four AC outlets (except the HG version). The HG version has an IEC mains socket and separate lead.

  Specification
  Continuous Power Output from 20Hz to 20,000Hz into 8Ω or 4Ω with no more than 0.1% THD	30 watts per channel, min. RMS
  THD (20Hz-20,000Hz)  Continuous rated power output  1 or 15 watts per channel  power output into 8Ω	0.1%   0.05%
  Intermodulation Distortion  Continuous rated power output  1 or 15 watts per channel  power output into 8Ω	0.1%   0.05%
  Output: Speaker              Headphone	A,B,A+B Low impedance
  Damping Factor (20Hz-20kHz 8Ω)	30
  Input Sensitivity/Impedance  PHONO  TUNER  AUX  TAPE PLAY1  TAPE PLAY2	2.5mV/50kΩ 150mV/50kΩ 150mV/50kΩ 150mV/50kΩ 150mV/50kΩ
  Output Level  TAPE REC1  TAPE REC2	150mV 150mV
  Frequency Response  PHONO (RIAA Equalization)  TUNER, AUX, TAPE PLAY	20Hz to 20,000Hz, ±0.3dB 10Hz to 40,000Hz +0dB,-1dB
  Hum and Noise (IHF, short circuited A Network)  PHONO  TUNER, AUX, TAPE PLAY	72dB 93dB

  Semiconductors:  2 ICs, 25 Transistors, 16 Diodes

  Preceded by the Pioneer SA-6500 Stereo Amplifier.

  Versions/Power requirements
  HG  Europe               /  220/240V AC 50/60Hz with voltage selector
  S     General Export  /  110/120/220/240V AC 50/60Hz with voltage selector
  KU   USA                  /  120V AC 60Hz
  KC   Canada             /  120V AC 60Hz

  Power consumption:  300W (HG), 90W (S), 100W (KU, KC)

• Peso neto
• 7.6 kg / 16 lb 11.8 oz (16.74 lb)

• Precio durante el primer año
• 170.00 CDN$

• Procedencia de los datos
• - - Data from my own collection

• Mencionado en
• - - Manufacturers Literature (1977 Pioneer Hi-Fi Components catalogue)

• Documentación / Esquemas (1)
• - - Manufacturers Literature (1977/78 Pioneer Hi-Fi Stereo catalogue)

• Documentación / Esquemas (2)
• - - Manufacturers Literature (Service Manual Pioneer SA-6500 II)

• Documentación / Esquemas (3)
• - - Manufacturers Literature (Operating Instructions Pioneer SA-6500 II)

• Autor
• Modelo creado por Robert Weaver. Ver en "Modificar Ficha" los participantes posteriores.

• Otros modelos

• Donde encontrará 1151 modelos, 1135 con imágenes y 201 con esquemas.
  Ir al listado general de Pioneer Corporation; Tokyo