Stereo Amplifier SA-610

Pioneer Corporation; Tokyo

Datos
Foro
Imágenes
Colecciones

  • Año
  • 1980/1981
  • Categoría
  • Amplificador de audio o mezclador
  • Radiomuseum.org ID
  • 193621

 Especificaciones técnicas

  • Numero de transistores
  • Hay semiconductores.
  • Semiconductores
  • Principio principal
  • Amplificador de Audio
  • Gama de ondas
  • - no hay
  • Especialidades
  • Hi-Fi equipment
  • Tensión de funcionamiento
  • Red: Corriente alterna (CA, Inglés = AC) / 120; 220; 240 Volt
  • Altavoz
  • - Este modelo usa altavoz exterior (1 o más).
  • Potencia de salida
  • 90 W (undistorted)
  • Material
  • Metálico
  • de Radiomuseum.org
  • Modelo: Stereo Amplifier SA-610 - Pioneer Corporation; Tokyo
  • Forma
  • Unidad para estanteria.
  • Ancho, altura, profundidad
  • 420 x 94 x 347 mm / 16.5 x 3.7 x 13.7 inch
  • Anotaciones

  • A hi-fi stereo integrated amplifier housed in a metal case with continuous power output of 45 watts per channel into 8 ohms. With fluorescent power meter, rotary controls for Volume, Balance, Bass and Treble, rotary Function selector (Tuner, Phono, Tape1, Aux), switches for Tape2, Loudness, Tone bypass and Subsonic filter, rotary switch for Loudspeakers (Off, A, B) and a jack for headphones. On the rear panel, RCA phono sockets for input Phono, Tuner and Aux, for input/output Tape1 and Tape2, terminals for 2 pairs of loudspeakers (A, B) and 3 AC outlets (except Australia), 2 switched and 1 unswitched.

    Specification  
    Amplifier Section  
    Continuous power output 45 watts per channel into 8Ω
    from 20Hz to 20,000Hz
    with no more than 0.03% THD
    Total Harmonic Distortion
     (20Hz to 20,000Hz, 8Ω, from AUX)
     22.5W per channel power output    		 No more than 0.02%
    Intermodulation Distortion
     8Ω, from AUX
     continuous rated power output    		 No more than 0.03%
    Input (Sensitivity/Impedance)  
     PHONO
     TUNER
     AUX
     TAPE PLAY 1, 2    		 2.5mV/50kΩ
    150mV/50kΩ
    150mV/50kΩ
    150mV/50kΩ
    Output (Level)  
     TAPE REC 1, 2
     Speaker    		 150mV
    A, B, OFF
    Frequency Response  
     PHONO (RIAA Equalization)
     TUNER, AUX, TAPE PLAY 1, 2    		 20Hz-20,000Hz ±0.3dB
    10Hz-60,000Hz ±3dB
    Subsonic Filter 15Hz (-6dB/oct)
    Hum and Noise
    (IHF, short-circuited, A network)    		  
     PHONO
     TUNER, AUX, TAPE PLAY 1, 2    		 82dB
    100dB

    Semiconductors: 3 ICs, 27 Transistors, 18 Diodes

    Versions/Power requirements
    USA        /  120V AC 60Hz
    Europe    /  220V AC 50/60Hz
    UK           /  240V AC 50/60Hz
    Australia  /  240V AC 50/60Hz

    Power consumption: 280 watts (Europe, UK, Australia), 100 watts (USA)

  • Peso neto
  • 6.9 kg / 15 lb 3.2 oz (15.198 lb)
  • Mencionado en
  • Discoteca HiFi, Anno XXI, n. 208-209, Agosto-Settembre 1980, Italy
  • Documentación / Esquemas (1)
  • - - Manufacturers Literature (1980/81 Pioneer Hi-Fi Stereo catalogue)
  • Documentación / Esquemas (2)
  • - - Manufacturers Literature (Service manual Pioneer SA-610 KU dated Dec 1979)
  • Autor
  • Modelo creado por Alessandro De Poi. Ver en "Modificar Ficha" los participantes posteriores.

 Colecciones | Museos | Literatura

Colecciones

El modelo Stereo Amplifier es parte de las colecciones de los siguientes miembros.

 Forum