Stroboscopic tuning fork
Ragg Tuning Forks; Sheffield
- Land
- Grossbritannien (UK)
- Hersteller / Marke
- Ragg Tuning Forks; Sheffield
- Jahr
- 1931 ??
- Kategorie
- Service- oder Labor-Ausrüstung
- Radiomuseum.org ID
- 304039
- Betriebsart / Volt
- Keine Stromversorgung
- Material
- Diverses Material
- von Radiomuseum.org
- Modell: Stroboscopic tuning fork - Ragg Tuning Forks; Sheffield
- Abmessungen (BHT)
- 290 x 43 x 22 mm / 11.4 x 1.7 x 0.9 inch
- Bemerkung
-
Electromechanical teleprinters, reperforators and paper tape readers that were driven by governed DC motors normally had stroboscopic target markings on the governor case to allow their speed to be set. For example, a motor that should run at 3000 rpm may have a governor marked with 5 white and 5 black segments, so that it should appear stationary when viewed at 250 Hz.
The calibration can be achieved simply by a 125 Hz tuning fork with overlapping slit shutters on the tines, through which the rotating governor can be viewed. Typically the governor is adjusted so that the motor is running slightly fast when idling, and slightly slow on full load, so that under normal operating conditions the speed is just right.
While the industry standard in Europe was 125 Hz, stroboscopic tuning forks were also made for 87.6 Hz, 120 Hz, 123.5 Hz, 140 Hz and 180 Hz. Steel tuning forks have a negative temperature coefficient and are normally calibrated at 20 deg C.
- Nettogewicht
- 0.3 kg / 0 lb 10.6 oz (0.661 lb)
- Autor
- Modellseite von Bruce Taylor angelegt. Siehe bei "Änderungsvorschlag" für weitere Mitarbeit.
- Weitere Modelle
-
Hier finden Sie 1 Modelle, davon 1 mit Bildern und 0 mit Schaltbildern.
Alle gelisteten Radios usw. von Ragg Tuning Forks; Sheffield
Sammlungen
Das Modell Stroboscopic tuning fork befindet sich in den Sammlungen folgender Mitglieder.