- Pays
- Etats-Unis
- Fabricant / Marque
- RCA (RCA Victor Co. Inc.); New York (NY)
- Année
- 1936
- Catégorie
- Radio - ou tuner d'après la guerre 1939-45
- Radiomuseum.org ID
- 53707
-
- alternative name: RCA Manufacturing || Victor Talking Machine
Cliquez sur la vignette du schéma pour le demander en tant que document gratuit.
- No. de tubes
- 6
- Principe général
- Super hétérodyne (en général); FI/IF 460 kHz
- Gammes d'ondes
- GO, OC et Police (Maritime)
- Tension / type courant
- Alimentation Courant Alternatif (CA) / See Notes Volt
- Haut-parleur
- HP dynamique à électro-aimant (électrodynamique) / Ø 8 inch = 20.3 cm
- Puissance de sortie
- 2 W (qualité inconnue)
- Matière
- Boitier en bois
- De Radiomuseum.org
- Modèle: 6T2 - RCA RCA Victor Co. Inc.; New
- Forme
- Modèle de table vertical décoré (pierre tombale)
- Dimensions (LHP)
- 13.7 x 19.8 x 8.5 inch / 348 x 503 x 216 mm
- Remarques
- same chassis as in console model 6K2.
This model has 3 power supply ratings:
Rating A...105-125V, 50-60 Cycles
Rating B...105-125V, 25-60 Cycles
Rating C...100-130;140-160;195-250V, 40-60 Cycles
- Poids net
- 24 lb (24 lb 0 oz) / 10.896 kg
- Prix de mise sur le marché
- 50.00 USD
- Source extérieure
- Ernst Erb
- Source du schéma
- Rider's Perpetual, Volume 7 = 1936 and before
- Littérature
- Collector's Guide to Antique Radios 4. Edition
- Schémathèque (1)
- RCA Victor Service Notes "Red Book" Series
- Schémathèque (2)
- Machine Age to Jet Age II (page 234.)
- Schémathèque (3)
- Cathedral & Tombstone Radios (page 213.)
- D'autres Modèles
-
Vous pourrez trouver sous ce lien 5130 modèles d'appareils, 3233 avec des images et 4167 avec des schémas.
Tous les appareils de RCA (RCA Victor Co. Inc.); New York (NY)
Collections
Le modèle 6T2 fait partie des collections des membres suivants.
Contributions du forum pour ce modèle: RCA RCA Victor Co.: 6T2
Discussions: 1 | Publications: 1
Hello all....I just wanted to share repair tips on this model. I received set with loud hum, that was not effected by volume control. I changed all caps . On the chassis are 3 'can' capacitors. One has its ground to chassis, the other two do not ( be aware of this, because the riders schematic is hard to read) After changing them, the hum was gone, but the set did not play. On check of voltages, I was not getting any screen voltages on 6K7 or 6A8. There is a voltage divider resistor mounted on chassis. I disconnected all leads to it, and found two sections were open ( 13K, and 3.5K ) . Replaced with 10 watt resistors, and she came to life! A good sounding radio, with fine tone, and sensitivity. Now to refinish the veneer! Al Pugliese
Alfred Pugliese, 21.Apr.08