Stereo Receiver RX-202MKII (2)

Rotel, The, Co., Ltd.; Tokyo

Datos
Foro
Imágenes
Colecciones

  • Año
  • 1976
  • Categoría
  • Radio - o Sintonizador pasado WW2
  • Radiomuseum.org ID
  • 150316

 Especificaciones técnicas

  • Numero de transistores
  • Hay semiconductores.
  • Semiconductores
  • Principio principal
  • Superheterodino en general
  • Gama de ondas
  • OM y FM
  • Especialidades
  • Hi-Fi equipment
  • Tensión de funcionamiento
  • Red: Corriente alterna (CA, Inglés = AC) / 100; 120; 220; 240 Volt
  • Altavoz
  • - Este modelo usa altavoz exterior (1 o más).
  • Potencia de salida
  • 40 W (undistorted)
  • Material
  • Madera
  • de Radiomuseum.org
  • Modelo: Stereo Receiver RX-202MKII - Rotel, The, Co., Ltd.; Tokyo
  • Forma
  • Unidad para estanteria.
  • Ancho, altura, profundidad
  • 475 x 115 x 250 mm / 18.7 x 4.5 x 9.8 inch
  • Anotaciones

  • An AM/FM stereo hi-fi receiver with a stereo tuner covering MW and FM and an integrated amplifier with output power of 2 x 20 watts RMS into 8 ohms. Housed in a walnut veneer cabinet with a black or silver front. Tuning Meter, Rotary Bass and Treble tone controls, push button switches for Speakers 1 and 2, High Filter, Loudness and Tape Monitor,  terminals for FM and AM antennae, RCA phono sockets for Tape/Aux input, RCA phono and DIN sockets for phono cartridge input (Magnetic and Ceramic) and for Tape Monitor Input/Output, terminals for two pairs of loudspeakers, a switch for simulated 4 channel, jack for headphones and a switched AC outlet.

    Specification  
    Amplifier Section  
    Continuous Power Output 20 watts per channel min. RMS
    both channels driven into 8Ω
    from 40 to 20,000Hz with
    no more than 1% Total Harmonic Distortion
    IM Distortion less than 0.2% at rated output
    Frequency Response 10 - 70,000 Hz ±3dB at 1 W/ch
    Damping Factor  30 (8Ω, 1kHz)
    Input Sensitivity/Impedance TAPE MONITOR 150mV/45kΩ
    AUX 150mV/45kΩ
    PHONO 2.5mV/45kΩ
    Tape Output (RCA) 300 m V/3.3kΩ
    (DIN) 100 mV/90kΩ
    Phono Equalization RIAA STD. ±1.0dB
    Crosstalk 50dB
    Hum and Noise (S/N)
     (continuous power output)    		 PHONO 70dB
    TAPE 85dB
    Residual 1.0mV
    Speaker Impedance 4 to 16Ω, SPKR 1 or 2
    8 to 16Ω, SPKR 1 + 2
    FM Tuner Section  
    Frequency Range 88 - 108 MHz
    Sensitivity (IHF) 2.5 µV (26dB), 5 µV
    Signal-to-Noise Ratio 70dB
    Harmonic Distortion 0.2% ( mono) 0.5% (stereo)
    Selectivity 45dB (alternate channel)
    Capture Ratio 3dB
    Stereo Separation 40dB at 1kHz, 30dB at 100 Hz
    IF Rejection 70dB
    Image Rejection 55dB
    Spurious Response Rejection 70dB
    AM Tuner Section  
    Frequency Range 525 to 1650 kHz
    Sensitivity 200 µV/m
    Selectivity 26dB
    IF Rejection  70dB
    Image Rejection 45dB

    Versions/Power Requirements
    120V AC 60Hz
    220V or 240V AC 50/60 Hz
    100/120/220/240V AC 50/60 Hz

    Power Consumption: 130W

    See also the similar earlier Rotel RX-202 Stereo Receiver.

  • Peso neto
  • 6.7 kg / 14 lb 12.1 oz (14.758 lb)
  • Procedencia de los datos
  • -- Original prospect or advert
  • Documentación / Esquemas (1)
  • - - Manufacturers Literature (Technical Manual RX-202 dated 1976)
  • Documentación / Esquemas (2)
  • - - Manufacturers Literature (Owner's Manual RX-202MKII AM/FM Stereo Receiver)
  • Autor
  • Modelo creado por Franz Scharner. Ver en "Modificar Ficha" los participantes posteriores.

 Colecciones | Museos | Literatura

Colecciones

El modelo Stereo Receiver es parte de las colecciones de los siguientes miembros.

 Forum