Integrated Amplifier AU-519

Sansui Electric Co., Ltd.; Tokyo

Daten
Forum
Bilder
Sammlungen

  • Jahr
  • 1979 ?
  • Kategorie
  • NF-(Niederfrequenz-) Verstärker oder -Mixer
  • Radiomuseum.org ID
  • 326703

 Technische Daten

  • Anzahl Transistoren
  • Halbleiter vorhanden.
  • Halbleiter
  • Hauptprinzip
  • NF-Verstärkung
  • Wellenbereiche
  • - ohne
  • Spezialitäten
  • Hi-Fi-Gerät
  • Betriebsart / Volt
  • Wechselstromspeisung / 100; 120; 220; 240 Volt
  • Lautsprecher
  • - Dieses Modell benötigt externe(n) Lautsprecher.
  • Belastbarkeit / Leistung
  • 140 W (sinus/unverzerrt)
  • Material
  • Metallausführung
  • von Radiomuseum.org
  • Modell: Integrated Amplifier AU-519 - Sansui Electric Co., Ltd.;
  • Form
  • Regalgerät wie HiFi-Komponente für Bücherwand.
  • Abmessungen (BHT)
  • 430 x 168 x 390 mm / 16.9 x 6.6 x 15.4 inch
  • Bemerkung

  • A hi-fi stereo integrated amplifier with power output of 2 x 70 watts RMS into 8 ohms, housed in a black metal case. Supplied with front rack handles which bolt on to the sides. Super Fidelity DC/DC. Pre-amplifier and Power amplifier sections can be separated. With rotary Volume, Balance, Treble and Bass controls, rotary switches for Speakers (Off, A, B A+B),  Input Selector (Aux, Tuner, Phono1, Phono2), Tape Copy (Off, Tuner, Source, S⇾1⇾2, S⇾2⇾1), push buttons for Tape Play Source, Tape1, Tape2, on/off switches for Power, Tone Defeat, Subsonic filter and Loudness, and a jack for headphones. On the back, Ground connection, phono sockets for input Phono1, Phono2, Tuner and Aux, for rec/play Tape1, Tape2, for Pre-amp out and Power Amp In, switch for Pre-Amp/Power amp connect/separate, terminals for two pairs of loudspeakers and 1 switched and 2 unswitched AC outlets.

    Specification  
    Power output  
     Min. RMS, both channels driven,
     from 10 - 20,000Hz,
     with no more than 0.008% THD    		 70 watts per channel into 8Ω
    Total harmonic distortion
    (POWER AMP IN)    		 < 0.008% at or below
    rated min. RMS power output
    Intermodulation distortion
    (70Hz : 7kHz = 4:1 SMPTE)
    (POWER AMP IN)    		 < 0.008% at or below
    rated min. RMS power output
    Rise Time 0.5µsec
    Slew Rate 160V/µsec
    Frequency response (at 1 watt)
    (POWER AMP IN)    		 DC to 400,00Hz +0dB -3dB
    Damping factor
    (1kHz, both channels driven)    		 100 into 8Ω
    RIAA curve deviation
    (PHONO, 20Hz to 20kHz)    		 +0.2dB, -0.2dB
    Input sensitivity/impedance
    (1kHz, for rated power output)    		  
      PHONO-1, 2 2.5mV/47kΩ
    (Max. input capability; 300mV at 1kHz,
    < 0.01 % total harmonic distortion)
     AUX, TUNER, TAPE PLAY 150mV/47kΩ
     POWER AMP IN 1V/47kΩ
    Output level/impedance (1kHz)  
     TAPE REC
     PREAMP OUT    		 150mV into 47kΩ/600Ω
    1V into 47kΩ/400Ω
    Channel separation
    (1kHz, at rated power output)    		  
     PHONO-1, 2
     AUX, TUNER, TAPE PLAY    		 70dB
    75dB
    Hum and noise
    (short-circuit, A-network)    		  
     PHONO-1, 2
     AUX, TUNER, TAPE PLAY    		 88dB
    100dB

    Versions/Power requirements
    General Export  /  100, 120, 220, 240V AC 50/60Hz
    USA and Canada  /  120V AC 60Hz
                                 
    Power consumption:  360 Watts (rated), 580 Watts (Max)

    Dimensions with rack handles (WHD) : 482 x 168 x 405 mm

  • Nettogewicht
  • 15.6 kg / 34 lb 5.8 oz (34.361 lb)
  • Literatur/Schema (1)
  • - - Manufacturers Literature (Service manual AU-519)
  • Autor
  • Modellseite von Howard Craven angelegt. Siehe bei "Änderungsvorschlag" für weitere Mitarbeit.

 Sammlungen | Museen | Literatur

 Forum