Model 1202 Dual Band Wattmeter

Ten-Tec Inc.; Sevierville, TN

  • Anno
  • 1995 ??
  • Categoria
  • Altro apparecchio amatoriale (ma non tasto Morse) 
  • Radiomuseum.org ID
  • 342546

 Specifiche tecniche

  • Gamme d'onda
  • Gamme d'onda nelle note.
  • Tensioni di funzionamento
  • Batterie / presa di alimentazione supplementare / 1 x 9 / 9 to 14 Volt
  • Altoparlante
  • - - Nessuna uscita audio.
  • Materiali
  • Mobile di metallo
  • Radiomuseum.org
  • Modello: Model 1202 Dual Band Wattmeter - Ten-Tec Inc.; Sevierville, TN
  • Dimensioni (LxAxP)
  • 6 x 3 x 4 inch / 152 x 76 x 102 mm
  • Annotazioni
  •  HF/VHF SWR Bridge and Wattmeter covering 1.8 - 54 MHz plus 2-Meters. Separate HF and VHF connectors allows connecting both rigs at the same time. Includes range switch for 20 or 200 watt scales, HF/VHF selection switch, and sensitivity control. Housed in a rugged steel enclosure.

    Specifications:

        Frequency Coverage: HF: 1.8 to 54 MHz, VHF: 140 to 150 MHz
        RF Power Ranges: 0 - 200 and 0 - 20 watts RF
        Wattmeter Accuracy: +/- 10% of full scale reading with 50 ohm resistive load
        SWR Sensitivity: better than 2 watts
        Impedance: 50 ohms nominal
        Circuitry: Separate HF and VHF sensing circuits, each with op-amp boosted forward and        reverse voltage outputs
        Battery Life: Approximately one week continuous (9V alkaline cell)
        External Power: 9 to 14 volts DC (2.1 mm connector, positive center)
        

     

  • Peso netto
  • 1.75 lb (1 lb 12 oz) / 0.795 kg
  • Prezzo nel primo anno
  • 49.00 USD
  • Bibliografia
  • QRP Amateur Radio Club International Quarterly ( Fall 1996)
  • Autore
  • Modello inviato da Greg Hubbard. Utilizzare "Proponi modifica" per inviare ulteriori dati.

 Collezioni | Musei | Letteratura

Collezioni

Il modello Model 1202 Dual Band Wattmeter fa parte delle collezioni dei seguenti membri.

 Forum