Aurora 6 Transistor

Unknown - CUSTOM BUILT: Japan

  • Year
  • 1960
  • Category
  • Broadcast Receiver - or past WW2 Tuner
  • Radiomuseum.org ID
  • 247810

 Technical Specifications

  • Number of Transistors
  • 6
  • Main principle
  • Superheterodyne (common)
  • Wave bands
  • Broadcast only (MW).
  • Power type and voltage
  • Dry Batteries / 1 x 9 Volt
  • Loudspeaker
  • Permanent Magnet Dynamic (PDyn) Loudspeaker (moving coil) / Ø 2.5 inch = 6.4 cm
  • Power out
  • 0.1 W (max.)
  • Material
  • Leather / canvas / plastic - over other material
  • from Radiomuseum.org
  • Model: Aurora 6 Transistor - Unknown - CUSTOM BUILT: Japan
  • Shape
  • Very small Portable or Pocket-Set (Handheld) < 8 inch.
  • Dimensions (WHD)
  • 150 x 95 x 50 mm / 5.9 x 3.7 x 2 inch
  • Notes
  • The circuit board forms the chassis of this radio with two seperate sub-chassis for the speaker and tuning gang. The case is tooled (embossed) leather with fibre board reinforcing to the flat sections. Transistors are "TEN" brand. There is a ferrite rod antenna 150 by 10 mm. A diode is shown on the circuit diagram as the detector but has no part number or designation marked on it. The circuit diagram is pasted to the inside rear of the case but has no component values, voltages or part numbers.

    Some resistors have modern colour coding but others are grey or cream paint dipped with no values indicated.

    The radio was advertised for sale through Radio House Sydney (Australia) at £19/17/6 in the December 1960 edition of Electronics Australia.

    Weight is without batteries. The battery is a PP3 held in a special purpose carrier by a spring steel clip.

  • Net weight (2.2 lb = 1 kg)
  • 0.440 kg / 0 lb 15.5 oz (0.969 lb)
  • Author
  • Model page created by Brian Wilson. See "Data change" for further contributors.

 Collections | Museums | Literature

Collections

The model Aurora 6 Transistor is part of the collections of the following members.

 Forum