- País
- Estados Unidos
- Fabricante / Marca
- Crosley Radio Corp.; Cincinnati (OH)
- Año
- 1946
- Categoría
- Radio - o Sintonizador pasado WW2
- Radiomuseum.org ID
- 36911
Crosley Chassis - Dial
Crosley chassis - top view
Crosley chassis - back
Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.
- Numero de valvulas
- 6
- Principio principal
- Superheterodino con paso previo de RF; ZF/IF 455 kHz; 2 Etapas de AF
- Gama de ondas
- OM y OC
- Tensión de funcionamiento
- Red: Corriente alterna (CA, Inglés = AC) / 110 Volt
- Altavoz
- Altavoz electrodinámico (bobina de campo)
- Potencia de salida
- 4.5 W (unknown quality)
- Material
- Madera
- de Radiomuseum.org
- Modelo: 66CA - Crosley Radio Corp.;
- Forma
- Consola en general
- Ancho, altura, profundidad
- 26.75 x 37.5 x 12 inch / 679 x 953 x 305 mm
- Ext. procedencia de los datos
- Ernst Erb
- Referencia esquema
- Rider's Perpetual, Volume 15 = 1947 and before
- Mencionado en
- Radio Retailing (Radio & Television R.) (April 1946 page 91.)
- Otros modelos
-
Donde encontrará 1791 modelos, 1048 con imágenes y 1282 con esquemas.
Ir al listado general de Crosley Radio Corp.; Cincinnati (OH)
Colecciones
El modelo 66CA es parte de las colecciones de los siguientes miembros.
Contribuciones en el Foro acerca de este modelo: Crosley Radio Corp.;: 66CA
Hilos: 1 | Mensajes: 44
Last March, I was trying to figure out what's wrong with this old Crosley chassis. I'm getting no output, but also no hum, just a little static when I turn the volume up or down.
Thomas Albrecht and several others of you were gracious to help me figure it out. I'm now back to that project and have determined the following: All voltages on all tubes are within or close to spec, except for the 6SQ7, 1st detector stage.
The readings on that tube are pin 2 -1v (and I do get a little hum from the speaker when testing). Pin 4 -1v Pin 6 75v (should be 110) Pin 7 6.3v ac
All other tubes measure spec or close to it.
Being a novice at this can you tell me what I should check next? Keep in mind that I'm just learning and don't have any test equipment besides a Simpson meter and a Precision tube tester.
Thanks so much, I haven't been in touch with the forum lately, but will try to be more active.
Dave Turner
Dave Turner, 14.Feb.10