- Pays
- Japon
- Fabricant / Marque
- JVC - Victor Company of Japan, Ltd.; Tokyo
- Année
- 1981/1982
- Catégorie
- Enrégistreur et/ou reproducteur son/video
- Radiomuseum.org ID
- 104880
- No. de transistors
- Semi-conducteurs présents
- Semi-conducteurs
- Principe général
- Amplification audio
- Gammes d'ondes
- - sans
- Particularités
- Magnétophone à cassettes; Equipement HIFI
- Tension / type courant
- Alimentation Courant Alternatif (CA) / 120; 220; 240 Volt
- Haut-parleur
- - Pour casque ou amplificateur BF
- Matière
- Boitier métallique
- De Radiomuseum.org
- Modèle: KD-D4 - JVC - Victor Company of Japan,
- Forme
- Appareil d'étagère
- Dimensions (LHP)
- 420 x 110 x 280 mm / 16.5 x 4.3 x 11 inch
- Remarques
- High performance, multi purpose stereo cassette tape deck.
- Poids net
- 7 kg / 15 lb 6.7 oz (15.419 lb)
- Auteur
- Modèle crée par d'un membre de D. Voir les propositions de modification pour les contributeurs supplémentaires.
- D'autres Modèles
-
Vous pourrez trouver sous ce lien 995 modèles d'appareils, 878 avec des images et 145 avec des schémas.
Tous les appareils de JVC - Victor Company of Japan, Ltd.; Tokyo
Contributions du forum pour ce modèle: JVC - Victor Company: KD-D4
Discussions: 2 | Publications: 4
Beside the necessity of tape speed regulation, sometimes it could be useful to put the 'transistor' (the active semiconductor that actually regulates the speed of the motor) outside the metal case of the motor itself, for the sake of cooling (see photos of the 03.Sep.06 message of Jens Dehne). I did it on some cassette recorder, where the transistor either had failed, or was prone to fail. So I mounted the new one outside the motor, on a small piece of alu sheetmetal acting as cooling fin. The three wire connection were soldered to the PCB thru a small hole drilled on the metal cover. This mod obviously apply to all cassette recorder, not only the JVC KD-D4.
Massimo Follaro, 28.May.13
Verehrte Kollegen,
der Motor meines Cassetten-Tonbandgerätes dreht konstant zu langsam (kein "eiern"), so daß die Frequenzen des Ausgangssignales ca. 200 Hz (geschätzt) zu tief sind. Die Antriebsmechanik (Getriebe, Riemen etc.) ist in Ordnung. Nun habe ich das Gerät genau untersucht, aber ein Poti zum Drehzahlabgleich finde ich nirgendwo. Ansonsten verhält sich der Recorder in allen Funktionen einwandfrei.
Welcher kompetente Fachmann weiß Rat? Mit Schaltungsunterlagen kann ich leider nicht dienen.
Eilert Menke, 03.Sep.06