• Anno
  • 1946–1948
  • Categoria
  • Radio (o sintonizzatore del dopoguerra WW2)
  • Radiomuseum.org ID
  • 272113

Clicca sulla miniatura dello schema per richiederlo come documento gratuito.

 Specifiche tecniche

  • Numero di tubi
  • 4
  • Principio generale
  • Supereterodina (in generale); ZF/IF 455 kHz; 2 Stadi BF; Reflex
  • N. di circuiti accordati
  • 6 Circuiti Mod. Amp. (AM)
  • Gamme d'onda
  • Onde medie (OM) e corte (OC).
  • Tensioni di funzionamento
  • Alimentazione a corrente alternata (CA) / 220; 240 Volt
  • Altoparlante
  • AP magnetodinamico (magnete permanente e bobina mobile) / Ø 5 inch = 12.7 cm
  • Materiali
  • Bachelite
  • Radiomuseum.org
  • Modello: Beehive 11-4CZ - Kriesler Radio Company;
  • Forma
  • Soprammobile compatto/con bordi arrotondati/midget senza pulsantiera/tastiera.<= 35 cm (Sometimes with handle but for mains only).
  • Dimensioni (LxAxP)
  • 250 x 230 x 210 mm / 9.8 x 9.1 x 8.3 inch
  • Annotazioni
  • There are 36 variants of this model:

    • CIRCUIT: As on 11-4 circuit but with the following alterations:- (Note: Enclosed diagram in lower right hand corner of sheet does not apply).
    1. Tone control (0.5 Megohm Potentiometer) replaced by 2 position, 0.02 μF 600v. condenser (C95) and 0.5 Megohm ½ watt resistor (R117). Disconnect lead from centre lug of potentiometer, and wire it to stationary contact of switch. Earth moving arm of switch. Replace potentiometer with fixed resistor.
    2. Speaker 70-1 changed to 70-8.
    3. H.T. choke (28-3) to replace field of 70-1 speaker.
    4. Power transformer 18-27 changed to 18-1.
    5. Coil Kit 15-2 changed to 15-10.
    6. Tuning condenser C3 changed to C79.
    7. 6J8G valve replaced by ECH35 converter.
    8. R103A (15,000 Ω) was replaced by R153A (40,000 Ω), R136 (30,000 Ω) was replaced by R153B (40,000 Ω).
    • COIL KIT: Part No. 15-10 (R.C. Tuning Condenser).
    • DIAL GLASSES: Part No. 50-26 (Principle section). Part No. 50-25 (Rear glass).
    • SPEAKER: Part No. 70-8 (5" Permanent magnet type).
    • OUTPUT TRANSFORMER: Part No. 18-26.
    • POWER TRANSFORMER: Part No. 18-1 (H.T.: 275v each side of centre tap).
  • Peso netto
  • 5 kg / 11 lb 0.2 oz (11.013 lb)
  • Prezzo nel primo anno
  • 18.90 AUS £
  • Bibliografia
  • HRSA Radio Waves magazine July 1996, Page 24-26 & Electronics Australia January 1998, Page 68-71.
  • Letteratura / Schemi (1)
  • - - Manufacturers Literature (Kriesler Technical Service Instructions.)
  • Autore
  • Modello inviato da Bruce Wilkie. Utilizzare "Proponi modifica" per inviare ulteriori dati.

 Collezioni | Musei | Letteratura

Collezioni

Il modello Beehive fa parte delle collezioni dei seguenti membri.

 Forum