• Año
  • 1954
  • Categoría
  • Radio - o Sintonizador pasado WW2
  • Radiomuseum.org ID
  • 105201

Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.

 Especificaciones técnicas

  • Numero de valvulas
  • 5
  • Principio principal
  • Superheterodino en general; ZF/IF 470 kHz; 2 Etapas de AF
  • Número de circuitos sintonía
  • 6 Circuíto(s) AM
  • Gama de ondas
  • OM, OL y OC
  • Tensión de funcionamiento
  • Red: Corriente alterna (CA, Inglés = AC) / 195-255 Volt
  • Altavoz
  • Altavoz dinámico (de imán permanente) / Ø 25 cm = 9.8 inch
  • Material
  • Madera
  • de Radiomuseum.org
  • Modelo: T38A - Marconi Co. Marconiphone,
  • Forma
  • Sobremesa de cualquier forma, detalles no conocidos.
  • Ancho, altura, profundidad
  • 420 x 325 x 220 mm / 16.5 x 12.8 x 8.7 inch
  • Anotaciones
  • Model plate is on base.

    The Output Transformer has a tap to act as choke for HT for V1 to V3 and V4 g2/Screen grid.

    The "earthy" pin of the P.U./Gram connector shorts out the Anode L.O. signal of the X148 Triode section to "disable" reception as the Wave band switch has no "Gram/PU." position. See the similar T26A and T29A (two preset stations and no choke tap on o/p but same loudspeaker, similar tuning scale, similar circuit on different chassis).

    The rear plate of scale has the index position for pointer when tuning is fully meshed as well as two calibration points for each band. R&TVS doesn't list the frequencies, nor are  the T29A alignment instructions suitable. The low frequency end of band marks are for L7, L9 and L10. In practice the trimmers (but not L.O. coils) for HF ends of bands can be aligned with the set in the Radio. 17MHz, 200m and 1000m scale positions are close to rear panel marks and can be used for the trimmer adjustments in the cabinet.

    Trimmer Capacitor designations may be only the R&TVS schematics.

    (check fully pointer aligns on right when fully meshed first)

      T38A
    Frequency L.O. R.F.
    17MHz (SW) TC3 TC6
    1500kHz (200m MW) TC4 TC1
    300kHz (1000m LW) TC5 TC2

    Order from side wall is LW, MW, SW. The R.F. trimmers are near scale on top of chassis and L.O. trimmers are on the rear of chassis,

    A large foil plate on one side wall of the cabinet functions as the internal aerial.

  • Mencionado en
  • -- Original-techn. papers.
  • Autor
  • Modelo creado por Peter Hoddow. Ver en "Modificar Ficha" los participantes posteriores.

 Colecciones | Museos | Literatura

Colecciones

El modelo es parte de las colecciones de los siguientes miembros.

 Forum