Solid State Stereo Amplifier AU-101

Sansui Electric Co., Ltd.; Tokyo

  • Año
  • 1973/1974
  • Categoría
  • Amplificador de audio o mezclador
  • Radiomuseum.org ID
  • 81247

Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.

 Especificaciones técnicas

  • Numero de transistores
  • 18
  • Semiconductores
  • Principio principal
  • Amplificador de Audio
  • Especialidades
  • Hi-Fi equipment
  • Tensión de funcionamiento
  • Red: Corriente alterna (CA, Inglés = AC) / 110; 117; 220; 240 Volt
  • Altavoz
  • - Este modelo usa altavoz exterior (1 o más).
  • Potencia de salida
  • 30 W (36 W max.)
  • Material
  • Materiales diversos
  • de Radiomuseum.org
  • Modelo: Solid State Stereo Amplifier AU-101 - Sansui Electric Co., Ltd.;
  • Forma
  • Unidad para estanteria.
  • Ancho, altura, profundidad
  • 407 x 115 x 278 mm / 16 x 4.5 x 10.9 inch
  • Anotaciones
  • A hi-fi stereo integrated amplifier housed in a metal case with wooden side panels with continuous power output of 2 x 15 watts into 8 ohms or 2 x 18 watts into 4 ohms. With rotary Power on/off switch, rotary Bass, Treble, Balance and Volume controls, rotary Selector switch (Mic, Phono, Aux), on/off switches for Speakers and Loudness, Tape Monitor switch (Source, Playback) with DIN socket, and jacks for Headphones and Microphone. On the back, Ground terminal, RCA phono sockets for input Phono and Aux, for Tape Rec and Play, terminals for 1 pair of loudspeakers and 1 switched and 1 unswitched AC outlet.

    Specification  
    POWER OUTPUT  
    MUSIC POWER (IHF) 50W into 4Ω, 44W into 8Ω
    CONTINUOUSE POWER 18+18W into 4Ω load
    15+15W into 8Ω load
    THD < 0.8% at rated output
    POWER BANDWIDTH (IHF) 25-40,000Hz
    FREQUENCY RESPONSE 20-60,000Hz ±2dB
    CHANNEL SEPARATION
     (at 1,000Hz, rated output)
    PHONO: > 45dB,  AUX: > 45dB
    HUM AND NOISE (IHF) PHONO: > 65dB,  AUX: > 75dB
    INPUT SENSITIVITY (at 1,000Hz)  
     PHONO
     MIC (MONO)
     AUX
     TAPE MON (pin)
     TAPE RECORDER (DIN)
    3mV (50kΩ)
    4mV (50kΩ)
    200mV (50kΩ)
    200mV (50kΩ)
    200mV (50kΩ)
    RECORDING OUTPUT  
     TAPE REC (pin)
     TAPE RECORDER (DIN)
    200mV
    30mV
    LOAD IMPEDANCE 4 to 16Ω
    EQUALIZER PHONO RIAA NF type, MIC: flat NF type

    Semiconductors: Transistors; 18, Diodes; 4
    Power Requirements: 100, 117, 220, 240V AC 50/60Hz with voltage selector
    Power Consumption:  30W (rated)

  • Peso neto
  • 5.9 kg / 12 lb 15.9 oz (12.996 lb)
  • Documentación / Esquemas (1)
  • - - Manufacturers Literature (Operating Instructions and Service Manual Sansui AU-101)
  • Autor
  • Modelo creado por Peter Böhm. Ver en "Modificar Ficha" los participantes posteriores.

 Colecciones | Museos | Literatura

Colecciones

El modelo Solid State Stereo Amplifier es parte de las colecciones de los siguientes miembros.

 Forum