Currawong 2x10W RMS Stereo Valve Amplifier Kit
Silicon Chip Publications Pty. Ltd; Brookvale NSW
- País
- Australia
- Fabricante / Marca
- Silicon Chip Publications Pty. Ltd; Brookvale NSW
- Año
- 2014/2015
- Categoría
- Amplificador de audio o mezclador
- Radiomuseum.org ID
- 324322
Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.
- Numero de valvulas
- 8
- Numero de transistores
- Hay semiconductores.
- Semiconductores
- Principio principal
- Amplificador de Audio; Hi-Fi-High End products
- Tensión de funcionamiento
- Red: Corriente alterna (CA, Inglés = AC) / 240 Volt
- Altavoz
- - Este modelo usa altavoz exterior (1 o más).
- Material
- Printed Circuit Board
- de Radiomuseum.org
- Modelo: Currawong 2x10W RMS Stereo Valve Amplifier Kit - Silicon Chip Publications Pty.
- Forma
- Chasis (tambien de autoradio)
- Ancho, altura, profundidad
- 294 x 186 x 304 mm / 11.6 x 7.3 x 12 inch
- Anotaciones
-
The Currawong amplifier is a stereo audio amplifier based on a design by Grant Wills in 2003 incorporating cheap, readily available 100V audio line transformers with the line impedance taps used in the class-AB ultra-linear output stage.
The Silicon Chip design used two 12AX7’s as pre-amp and phase splitter with two 6L6 beam power Triodes as the push-pull output stage, per channel. It also incorporated a delayed B+ soft start circuit.
It was described in Silicon Chip in November, December 2014 and January 2015.
It sold on kit form, without a case from Altronics Pty. Ltd. for around $700.
The Editor of Silicon Chip, Nicholas Vinen explains that the Currawong name recognises the very musical call of the bird.
A Pied Currawong is an Australian native bird about the size of a Crow or Raven and is mostly all black except for the telling white wing & tail feathers. Known for its melodious calls, the species' name currawong is believed to be of indigenous origin.
Output power: 2 x 10W (8Ω, 6Ω), 2 x 9W (4Ω) Operating mode: Class-A (8Ω), Class-A/AB (6Ω, 4Ω) Input sensitivity: 1V RMS (8Ω, with feedback enabled)
Signal-to-noise ratio: 77dB Channel separation: >60dB, 20Hz-20kHz (4Ω, 6Ω & 8Ω) Harmonic distortion: typically, <0.1%, 6Ω & 8Ω
Frequency response: ±0.6dB, 30Hz-20kHz Damping factor: >20 (8Ω), >10 (4Ω) Mains power draw: typically, 120-130W
- Precio durante el primer año
- 700.00 AUS $
- Mencionado en
- Silicon Chip Magazine Nov, Dec 2014, Jan 2015
- Autor
- Modelo creado por Gary Cowans. Ver en "Modificar Ficha" los participantes posteriores.
- Otros modelos
-
Donde encontrará 2 modelos, 1 con imágenes y 2 con esquemas.
Ir al listado general de Silicon Chip Publications Pty. Ltd; Brookvale NSW
Colecciones
El modelo Currawong 2x10W RMS Stereo Valve Amplifier Kit es parte de las colecciones de los siguientes miembros.