Concertino Hi-Fi Stereo 5093W
Telefunken Deutschland (TFK), (Gesellschaft für drahtlose Telegraphie Telefunken mbH
- Paese
- Germania
- Produttore / Marca
- Telefunken Deutschland (TFK), (Gesellschaft für drahtlose Telegraphie Telefunken mbH
- Anno
- 1959 ?
- Categoria
- Radio (o sintonizzatore del dopoguerra WW2)
- Radiomuseum.org ID
- 110227
Clicca sulla miniatura dello schema per richiederlo come documento gratuito.
- Numero di tubi
- 9
- Numero di transistor
- Principio generale
- Supereterodina (in generale); ZF/IF 460/10700 kHz; Modello per l'esportazione
- Gamme d'onda
- Onde medie (OM), 2 gamme di onde corte (2 x OC) e MF (FM).
- Tensioni di funzionamento
- Alimentazione a corrente alternata (CA) / 115; 230 Volt
- Altoparlante
- 3 altoparlanti
- Materiali
- Mobile in legno
- Radiomuseum.org
- Modello: Concertino Hi-Fi Stereo 5093W - Telefunken Deutschland TFK,
- Forma
- Soprammobile con pulsantiera/tastiera.
- Dimensioni (LxAxP)
- 24 x 14 x 10.5 inch / 610 x 356 x 267 mm
- Annotazioni
-
Telefunken Concertino Hi-Fi Stereo 5093W (Hi-Fi System) is an export model with MW (515 - 1630 kHz), 2 SW (2.2 - 6.9 MHz and 6.8 - 22.5 MHz), and FM (87.5 - 108 MHz) ranges.
It has 3 loudspeakers: 1 elliptical full range 18 x 26 cm and 2 tweeters Ø 10 cm.
See also the similar model Concertino Hi-Fi Stereo 5093W trop which has "Hi-Fi System" written on the back cover, not on the dial.
- Letteratura / Schemi (4)
- -- Original-techn. papers.
- Altri modelli
-
In questo link sono elencati 3571 modelli, di cui 3157 con immagini e 2114 con schemi.
Elenco delle radio e altri apparecchi della Telefunken Deutschland (TFK), (Gesellschaft für drahtlose Telegraphie Telefunken mbH
Collezioni
Il modello Concertino Hi-Fi Stereo fa parte delle collezioni dei seguenti membri.
Discussioni nel forum su questo modello: Telefunken: Concertino Hi-Fi Stereo 5093W
Argomenti: 3 | Articoli: 10
Hello,
I have an alignment question about this radio. When I received it, the i.f. rejector circuit coil, marked '10' on the alignment point diagram, was not properly connected. I have reconnected it properly, and I want to make sure that it is adjusted correctly, since it appears to have been replaced by a previous owner.
I have completely re-capped the radio. This is the only alignment I want to attempt, since the radio appears to be working correctly, and all of the other coils and capacitors referenced in the alignment documentation are still sealed with the original wax or sealing compound.
The documentation I refer to is attached to this model on the RM website.
In the alignment procedures for the IF rejector circuit, it is stated that the signal generator should be set to 460 khz, radio set at 800 khz, and the signal generator connected to the radio 'via 10000 pF to Ka 4'. I can find no point in the radio schematic or alignment documentation that is labeled 'Ka 4'.
One of the capacitors which can be adjusted is labelled as 'K', but it is also referenced in the alignment 'sequence' documentation as 'K'.
There are two multiposition switches, marked 'K1' and 'K2', one of which uses position 4 on the 'a' side, but it does not seem to make sense to connect to this position with the signal generator for alignment.
Also, where would I connect to measure minimum output for correct alignment? Across the speaker output or audio output transformer?
Any help would be greatly appreciated. As stated before, the radio appears to be working well so I am going to leave it adjusted as it is until I get an answer here.
Thank you, Joe
Joe Brown, 08.Jun.14
Does anyone know how the knobs connect to the indicators? Is it a cord, a rubber band or something else? Gary
Allegati
- telefunken (77 KB)
John Kershaw, 13.Dec.06