University Sweep & Marker Generator TVR/SM
University / University Graham Instruments Pty. Ltd., Radio Equipment Pty. Ltd.; Sydney
- Paese
- Australia
- Produttore / Marca
- University / University Graham Instruments Pty. Ltd., Radio Equipment Pty. Ltd.; Sydney
- Anno
- 1962 ??
- Categoria
- Strumento da laboratorio
- Radiomuseum.org ID
- 359391
- Numero di tubi
- 5
- Valvole
- Gamme d'onda
- Gamme d'onda nelle note.
- Tensioni di funzionamento
- Alimentazione a corrente alternata (CA) / 240 Volt
- Altoparlante
- - - Nessuna uscita audio.
- Materiali
- Mobile di metallo
- Radiomuseum.org
- Modello: University Sweep & Marker Generator TVR/SM - University / University Graham
- Forma
- Soprammobile con qualsiasi forma (non saputo).
- Dimensioni (LxAxP)
- 13 x 9.5 x 7 inch / 330 x 241 x 178 mm
- Annotazioni
-
The University Sweep & Marker Generator TVR/SM is a testing device designed for signal generation and frequency analysis of television and FM receivers.
This instrument integrates two key components: sweep and marker generators.The sweep generator produces a signal that varies in frequency from 4.5 MHz to 220 MHz, covering all fundamental frequencies. It features an adjustable sweep width, allowing precise control over the analysed frequency range.
The marker generator consists of two distinct markers:
- A crystal-controlled marker fixed at 5.5 MHz, with the option to use external crystals for other frequencies.
- A variable marker that operates from 20 to 60 MHz on fundamentals, with ranges extending up to 240 MHz using harmonics. This marker dial is directly calibrated for ease of use.
The instrument generates an RF signal that sweeps several MHz on either side of a centre frequency, which is selected using the tuning dial and range switch. The tuning ranges are organized as follows:
- Range 1: Covers sound IF bands, including 5.5 and 10.7 MHz.
- Range 2: Encompasses all TV standard and non-standard IF frequencies.
- Range 3: Spans low band channels 1 to 3.
- Range 4: Covers high band channels 4 to 10.
Operation;
A sweep generator is typically connected to a Cathode Ray Oscilloscope in the following manner:
- The RF output of the sweep generator is connected to the input of the circuit under test.
- The detector output of the circuit under test is then connected to the vertical input of the oscilloscope.
- The sweep generator's horizontal output (often a ramp signal or gate signal) is connected to the external horizontal input of the oscilloscope.
- This setup allows the oscilloscope to display the frequency response of the circuit under test as the sweep generator varies its output frequency. The horizontal axis of the oscilloscope display represents frequency, while the vertical axis shows the amplitude response of the circuit
This versatile device is particularly useful for aligning IF stages in televisions and FM receivers.
- Fonte dei dati
- - - Manufacturers Literature
- Bibliografia
- - - Manufacturers Literature (University Graham Instruments Pty.,Catalogue c1960)
- Autore
- Modello inviato da Gordon Markwart. Utilizzare "Proponi modifica" per inviare ulteriori dati.
- Altri modelli
-
In questo link sono elencati 25 modelli, di cui 25 con immagini e 6 con schemi.
Elenco delle radio e altri apparecchi della University / University Graham Instruments Pty. Ltd., Radio Equipment Pty. Ltd.; Sydney
Collezioni
Il modello University Sweep & Marker Generator fa parte delle collezioni dei seguenti membri.