Monitorscope YO-100
Yaesu-Musen Co. Ltd.; Tokyo
- Pays
- Japon
- Fabricant / Marque
- Yaesu-Musen Co. Ltd.; Tokyo
- Année
- 1965 ??
- Catégorie
- Appareil amateur (divers et sans touches)
- Radiomuseum.org ID
- 183703
Cliquez sur la vignette du schéma pour le demander en tant que document gratuit.
- No. de tubes
- 5
- No. de transistors
- 11
- Semi-conducteurs
- Principe général
- Appareillage spécial ? Renseignements souhaités SVP.
- Gammes d'ondes
- - sans
- Tension / type courant
- Alimentation Courant Alternatif (CA) / 100/110/117/200/220/234 Volt
- Haut-parleur
- - - Pas de sortie basse fréquence
- Matière
- Boitier métallique
- De Radiomuseum.org
- Modèle: Monitorscope YO-100 - Yaesu-Musen Co. Ltd.; Tokyo
- Forme
- Modèle de table générique
- Dimensions (LHP)
- 210 x 150 x 290 mm / 8.3 x 5.9 x 11.4 inch
- Remarques
- The Yaesu YO-100 is a station monitor scope that will allow you to monitor and adjust your transmitter for the cleanest signal possible. The YO-100 is compatible with virtually all transmitters and transceivers. The cabinet and front panel design of the YO-100 matches that of the FT-101B/277B and FT-201 series of Yaesu equipment. The features include a wide range of inputs for monitoring many different modes, such as SSB, CW and Digital. A built-in 1500 Hz and 1900 Hz tone generators greatly adds to the versatility of this station accessory. This two-tone generator produces the proper audio signals to perform a "trapezoidal" pattern for testing the linearity of a transmitter or amplifier.
The specifications are as follows, for the vertical trace the sensitivity is 200 mV P-P/cm and the frequency response is 10Hz to 60MHz. For the horizontal trace the sensitivity is 300 mV/cm, the frequency response is 10Hz to 16kHz and the sweep frequency is 10 Hz to 10 kHz. The two-tone generator frequency is 1500 Hz and 1900 Hz which is Independently selectable by front panel controls and has an output level of 50 mV.
The YO-100 uses 5 tubes in it's circuit which are as follows, a 12BY7A as an Audio Frequency Amplifier, a 12BY7A as an I.F. Amplifier, a 12AT7 as a Clamp, a 3RP1A as the Cathode Ray Tube and a 6AL5 as a R.F. Detector.
- Poids net
- 6 kg / 13 lb 3.5 oz (13.216 lb)
- Source
- - - Data from my own collection
- Auteur
- Modèle crée par Marco Pogliani. Voir les propositions de modification pour les contributeurs supplémentaires.
- D'autres Modèles
-
Vous pourrez trouver sous ce lien 305 modèles d'appareils, 289 avec des images et 139 avec des schémas.
Tous les appareils de Yaesu-Musen Co. Ltd.; Tokyo
Collections
Le modèle Monitorscope fait partie des collections des membres suivants.