Monitorscope YO-100

Yaesu-Musen Co. Ltd.; Tokyo

  • Anno
  • 1965 ??
  • Categoria
  • Altro apparecchio amatoriale (ma non tasto Morse) 
  • Radiomuseum.org ID
  • 183703

Clicca sulla miniatura dello schema per richiederlo come documento gratuito.

 Specifiche tecniche

  • Numero di tubi
  • 5
  • Numero di transistor
  • 11
  • Semiconduttori
  • Principio generale
  • Apparecchiatura speciale (descrivere nelle note)
  • Gamme d'onda
  • - senza
  • Tensioni di funzionamento
  • Alimentazione a corrente alternata (CA) / 100/110/117/200/220/234 Volt
  • Altoparlante
  • - - Nessuna uscita audio.
  • Materiali
  • Mobile di metallo
  • Radiomuseum.org
  • Modello: Monitorscope YO-100 - Yaesu-Musen Co. Ltd.; Tokyo
  • Forma
  • Soprammobile con qualsiasi forma (non saputo).
  • Dimensioni (LxAxP)
  • 210 x 150 x 290 mm / 8.3 x 5.9 x 11.4 inch
  • Annotazioni
  • The Yaesu YO-100 is a station monitor scope that will allow you to monitor and adjust your transmitter for the cleanest signal possible. The YO-100 is compatible with virtually all transmitters and transceivers. The cabinet and front panel design of the YO-100 matches that of the FT-101B/277B and FT-201 series of Yaesu equipment. The features include a wide range of inputs for monitoring many different modes, such as SSB, CW and Digital. A built-in 1500 Hz and 1900 Hz tone generators greatly adds to the versatility of this station accessory. This two-tone generator produces the proper audio signals to perform a "trapezoidal" pattern for testing the linearity of a transmitter or amplifier.
    The specifications are as follows, for the vertical trace the sensitivity is 200 mV P-P/cm and the frequency response is 10Hz to 60MHz. For the horizontal trace the sensitivity is 300 mV/cm, the frequency response is 10Hz to 16kHz and the sweep frequency is 10 Hz to 10 kHz. The two-tone generator frequency is 1500 Hz and 1900 Hz which is Independently selectable by front panel controls and has an output level of 50 mV.
    The YO-100 uses 5 tubes in it's circuit which are as follows, a 12BY7A as an Audio Frequency Amplifier, a 12BY7A as an I.F. Amplifier, a 12AT7 as a Clamp, a 3RP1A as the Cathode Ray Tube and a 6AL5 as a R.F. Detector.
  • Peso netto
  • 6 kg / 13 lb 3.5 oz (13.216 lb)
  • Fonte dei dati
  • - - Data from my own collection
  • Autore
  • Modello inviato da Marco Pogliani. Utilizzare "Proponi modifica" per inviare ulteriori dati.

 Collezioni | Musei | Letteratura

Collezioni

Il modello Monitorscope fa parte delle collezioni dei seguenti membri.

 Forum