Monitorscope YO-100

Yaesu-Musen Co. Ltd.; Tokyo

  • Año
  • 1965 ??
  • Categoría
  • Radioaficionados; Complemento (menos manipulador).
  • Radiomuseum.org ID
  • 183703

Haga clic en la miniatura esquemática para solicitarlo como documento gratuito.

 Especificaciones técnicas

  • Numero de valvulas
  • 5
  • Numero de transistores
  • 11
  • Semiconductores
  • Principio principal
  • something special ? Please give information (notes)
  • Gama de ondas
  • - no hay
  • Tensión de funcionamiento
  • Red: Corriente alterna (CA, Inglés = AC) / 100/110/117/200/220/234 Volt
  • Altavoz
  • - - No hay salida de sonido.
  • Material
  • Metálico
  • de Radiomuseum.org
  • Modelo: Monitorscope YO-100 - Yaesu-Musen Co. Ltd.; Tokyo
  • Forma
  • Sobremesa de cualquier forma, detalles no conocidos.
  • Ancho, altura, profundidad
  • 210 x 150 x 290 mm / 8.3 x 5.9 x 11.4 inch
  • Anotaciones
  • The Yaesu YO-100 is a station monitor scope that will allow you to monitor and adjust your transmitter for the cleanest signal possible. The YO-100 is compatible with virtually all transmitters and transceivers. The cabinet and front panel design of the YO-100 matches that of the FT-101B/277B and FT-201 series of Yaesu equipment. The features include a wide range of inputs for monitoring many different modes, such as SSB, CW and Digital. A built-in 1500 Hz and 1900 Hz tone generators greatly adds to the versatility of this station accessory. This two-tone generator produces the proper audio signals to perform a "trapezoidal" pattern for testing the linearity of a transmitter or amplifier.
    The specifications are as follows, for the vertical trace the sensitivity is 200 mV P-P/cm and the frequency response is 10Hz to 60MHz. For the horizontal trace the sensitivity is 300 mV/cm, the frequency response is 10Hz to 16kHz and the sweep frequency is 10 Hz to 10 kHz. The two-tone generator frequency is 1500 Hz and 1900 Hz which is Independently selectable by front panel controls and has an output level of 50 mV.
    The YO-100 uses 5 tubes in it's circuit which are as follows, a 12BY7A as an Audio Frequency Amplifier, a 12BY7A as an I.F. Amplifier, a 12AT7 as a Clamp, a 3RP1A as the Cathode Ray Tube and a 6AL5 as a R.F. Detector.
  • Peso neto
  • 6 kg / 13 lb 3.5 oz (13.216 lb)
  • Procedencia de los datos
  • - - Data from my own collection
  • Autor
  • Modelo creado por Marco Pogliani. Ver en "Modificar Ficha" los participantes posteriores.

 Colecciones | Museos | Literatura

Colecciones

El modelo Monitorscope es parte de las colecciones de los siguientes miembros.

 Forum