Skipper 196A

Philips Australia

Données
Forum
Images
Collections

  • Année
  • 1959
  • Catégorie
  • Radio - ou tuner d'après la guerre 1939-45
  • Radiomuseum.org ID
  • 234056

 Spécifications techniques

  • No. de tubes
  • 4
  • Principe général
  • Super hétérodyne (en général); FI/IF 455 kHz
  • Gammes d'ondes
  • PO uniquement
  • Tension / type courant
  • Secteur et Piles (tous types). / 200 - 250 / 7.5 & 90 Volt
  • Haut-parleur
  • HP dynamique à aimant permanent + bobine mobile / Ø 4 inch = 10.2 cm
  • Matière
  • Cuir / canvas / plastique mais autre matériel en dessous!
  • De Radiomuseum.org
  • Modèle: Skipper 196A - Philips Australia
  • Forme
  • Portative > 20 cm (sans nécessité secteur)
  • Dimensions (LHP)
  • 280 x 180 x 120 mm / 11 x 7.1 x 4.7 inch
  • Remarques

  • Batteries needed were a 7.5 volt "A" battery (No 717 or 3717) and a 90 volt "B" battery (No 490P or 3490P). The paperwork inside the case says that the radio "Incorporates automatic "B" battery recharging." but the method is in the "Instruction Book".

    Mains rectification is by a half wave Selenium Rectifier and filament voltage is derived from the HT by dropping resistors.

    There is a switch for selecting mains or battery power or OFF under the handle connector on one side of the radio. This switch is brass and apart from this, the radio would probably qualify as "Double Insulated" by modern standards.

    A protector plate was installed between the batteries and the under-chassis components.

    See also similar model 196.

    Colours available in Champagne, Cherry & Grey with matching piping..

  • Poids net
  • 4 lb 7 oz (4.438 lb) / 2.015 kg
  • Prix de mise sur le marché
  • 23.10 AUS £

 Collections | Musées | Littérature

 Forum