Skipper 196A

Philips Australia

Dati
Forum
Immagini
Collezioni

  • Anno
  • 1959
  • Categoria
  • Radio (o sintonizzatore del dopoguerra WW2)
  • Radiomuseum.org ID
  • 234056

 Specifiche tecniche

  • Numero di tubi
  • 4
  • Principio generale
  • Supereterodina (in generale); ZF/IF 455 kHz
  • Gamme d'onda
  • Solo onde medie (OM).
  • Tensioni di funzionamento
  • Rete / Batterie (ogni tipo) / 200 - 250 / 7.5 & 90 Volt
  • Altoparlante
  • AP magnetodinamico (magnete permanente e bobina mobile) / Ø 4 inch = 10.2 cm
  • Materiali
  • Pelle / stoffa / plastica ma con altro materiale sottostante
  • Radiomuseum.org
  • Modello: Skipper 196A - Philips Australia
  • Forma
  • Apparecchio portatile > 20 cm (senza la necessità di una rete)
  • Dimensioni (LxAxP)
  • 280 x 180 x 120 mm / 11 x 7.1 x 4.7 inch
  • Annotazioni

  • Batteries needed were a 7.5 volt "A" battery (No 717 or 3717) and a 90 volt "B" battery (No 490P or 3490P). The paperwork inside the case says that the radio "Incorporates automatic "B" battery recharging." but the method is in the "Instruction Book".

    Mains rectification is by a half wave Selenium Rectifier and filament voltage is derived from the HT by dropping resistors.

    There is a switch for selecting mains or battery power or OFF under the handle connector on one side of the radio. This switch is brass and apart from this, the radio would probably qualify as "Double Insulated" by modern standards.

    A protector plate was installed between the batteries and the under-chassis components.

    See also similar model 196.

    Colours available in Champagne, Cherry & Grey with matching piping..

  • Peso netto
  • 4 lb 7 oz (4.438 lb) / 2.015 kg
  • Prezzo nel primo anno
  • 23.10 AUS £

 Collezioni | Musei | Letteratura

 Forum