Skipper 196A

Philips Australia

Datos
Foro
Imágenes
Colecciones

  • Año
  • 1959
  • Categoría
  • Radio - o Sintonizador pasado WW2
  • Radiomuseum.org ID
  • 234056

 Especificaciones técnicas

  • Numero de valvulas
  • 4
  • Principio principal
  • Superheterodino en general; ZF/IF 455 kHz
  • Gama de ondas
  • OM (onda media) solamente
  • Tensión de funcionamiento
  • Red / Baterías o pilas / 200 - 250 / 7.5 & 90 Volt
  • Altavoz
  • Altavoz dinámico (de imán permanente) / Ø 4 inch = 10.2 cm
  • Material
  • Cuero/Tela/ Plástico sobre otros materiales
  • de Radiomuseum.org
  • Modelo: Skipper 196A - Philips Australia
  • Forma
  • Portátil > 20 cm (sin la necesidad de una red)
  • Ancho, altura, profundidad
  • 280 x 180 x 120 mm / 11 x 7.1 x 4.7 inch
  • Anotaciones

  • Batteries needed were a 7.5 volt "A" battery (No 717 or 3717) and a 90 volt "B" battery (No 490P or 3490P). The paperwork inside the case says that the radio "Incorporates automatic "B" battery recharging." but the method is in the "Instruction Book".

    Mains rectification is by a half wave Selenium Rectifier and filament voltage is derived from the HT by dropping resistors.

    There is a switch for selecting mains or battery power or OFF under the handle connector on one side of the radio. This switch is brass and apart from this, the radio would probably qualify as "Double Insulated" by modern standards.

    A protector plate was installed between the batteries and the under-chassis components.

    See also similar model 196.

    Colours available in Champagne, Cherry & Grey with matching piping..

  • Peso neto
  • 4 lb 7 oz (4.438 lb) / 2.015 kg
  • Precio durante el primer año
  • 23.10 AUS £

 Colecciones | Museos | Literatura

 Forum